How do you clear a Trane error code?

How do you clear a Trane error code?

To have your Trane air conditioner reset (and clear an error code), all you need to do is simply reset the circuit breaker. We suggest you wait a couple of minutes before restarting the unit.

How do I reset my Trane HVAC?

How to Reset a Trane HVAC After a Power Loss

1. Turn the thermostat to the “Off” position. Wait a few minutes, then turn the thermostat either to “Heat” or “Cool.”
2. Set the thermostat to the desired temperature.
3. Go to the circuit breaker box if you do not feel or hear airflow.
4. Turn the thermostat off and then on again.

Why is my Trane AC running but not cooling?

Your filters may be clogged or dirty Clean or replace the filters. Consult your local Trane Comfort Specialist™ if you are unsure where the filters are located. Your thermostat controls may be set incorrectly Try turning the thermostat off and then on again. Reset to the desired temperature and see if that helps.

How do I contact Trane tech support?

1-844-529-8237
Call us at 1-844-529-8237.

Why is my Trane AC blinking red?

The red blinking light for your Trane XR90 furnace indicates that your unit was shut off due to a problem. When your red light is continuously on it indicates the circuit board needs replacement. Another part of the red light system is when it is continuously off, this shows you need to check the power of your furnace.

What does ESM mean on Trane thermostat?

Energy Savings Mode
indoor unit. • Upgradable software. • Screen lock out and guest lock out. • One button Energy Savings Mode (ESM) Trane XL824 Control.

Why is my Trane blowing cold air?

Your furnace may be blowing cold air because the filter is too dirty. A dirty air filter blocks airflow over the furnace’s heat exchanger, causing it to overheat. When overheating, your furnace can trip a high limit switch, causing the furnace burners to shut off so that the heat exchanger does not crack.

Does Trane have tech support?

Expert support. 24/7. We’re always here for you.

Why is my Trane thermostat error code 26?

Trane thermostat error code 26 If you see the 26 fault code on the display, your unit is overheating. The error appears when the furnace exceeds the set temp limit. Most likely, it is because of a dirty filter, blocked fan, dirty ac coil and/or blocked air duct.

What does error code 126 on Trane display mean?

Error 126 is simply a communication fault, (communication error between inside/outside unit)Turn the breaker off to the outside unitand also Turn the breaker off to the inside unitwait a minute and turn them back on, this should clear the fault, if not please let me know and we’ll check further. Thanks! – Tamar Ask Your Own HVAC Question

What does the 79 mean on a Trane thermostat?

Trane thermostat error code 79. The 79 fault code means that the low pressure switch is released. This happens when the evaporator coil gets iced up, air filter gets dirty, the system runs low on refrigerant, or when there is a problem in the printed circuit board.

What does a code mean on a Trane furnace?

Not every furnace codes means you’re looking at a serious furnace repair in your future. In fact, some codes are there to let you know that your system is functioning properly. If you notice a light on your Trane furnace that is flashing slowly, this means that your furnace is on but it is not calling for heat.