How do I reset my password on my Catalyst 2950?

How do I reset my password on my Catalyst 2950?

Step-by-Step Procedure

1. Attach a terminal or PC with terminal emulation (for example, Hyper Terminal) to the console port of the switch.
2. Unplug the power cable.
3. Power the switch and bring it to the switch: prompt:
4. Issue the flash_init command.
5. Issue the load_helper command.
6. Issue the dir flash: command.

How do I factory reset my Catalyst 2960?

Press and hold the front panel MODE button, and power-up the switch. – After a few seconds, the following should display. Release the MODE button.

How do you hard reset a cat phone?

How do I perform a reset, when my screen is blank?

1. The device has an embedded battery that can only be accessed by authorised personnel.
2. To reset the device, open the SIM card and SD card door, behind the door to the right is an “OFF” button.
3. Depress this button and the device will power down, restart the device.

How do I reset my Nintendo password?

If you have forgotten your password, you can reset it from the “Forgot Your Password?” link (https://accounts.nintendo.com/password/reset) that can be found on the Nintendo Account sign in page.

How do I clear my Cisco router configuration?

Clear the configuration of your switch

1. Log on to your switch, and enter the privileged EXEC mode by entering enable and then entering the enable password command.
2. Enter clear config all to reset the entire system. You don’t need to reload the switch because processing the command wipes the switch.

How do I factory reset my Cisco router?

The prompt changes to Router#, indicating that the router is now in privileged mode. To enter config mode, issue the config terminal command. You should now see a Router(config)# prompt. To break out of configuration mode, press Cntl and Z.

How do I factory Reset my Cisco router?

How do I wipe my Cisco router?

Follow these steps:

1. Log on to your switch, and enter the privileged EXEC mode by entering enable and then entering the enable password command.
2. Enter write erase, which erases the NVRAM file system and removes all files.
3. At the prompt, confirm that you want to erase all files.

How to recover password on Cisco Catalyst 2950?

To start the password recovery procedure for the Catalyst 2950, just follow the instructions in the link above. Or the abbreviated version here: Unplug the switch. Press and hold the “Mode” button while plugging in the switch. Release the “Mode” button once the “Stat” stops blinking green (~5 sec)

How can I Reset my CatOS switch to factory settings?

You can reset the system or module configuration on these switches running CatOS to factory defaults with the clear config command. The command syntax is: clear config {mod | rmon | all | snmp | acl {nvram}}. The clear config all command clears the system configuration, as well as the module configuration.

How do I Reset my Catalyst switch to factory default?

To reset the Catalyst switches to factory defaults, you need access to the switch console through either a physical console or a Telnet connection. You also need the console/enable passwords. If you forget the console and enable password of your switch, you cannot reset the switch configuration to factory default to reset the password.