How to start tecnai T12 September 13, 2013?

How to start tecnai T12 September 13, 2013?

TECNAI T12 September 2013 Start-of-Session Steps 1. Add LN 2to ACD dewar. Check level during session. DO NOT allow to dry! 2. Log into Windows with your username and password. 3. Open TECNAI USER INTERFACE; Open TIA. 4. Load Sample. Put sample onto chosen sample holder (single tilt; double tilt.)

Can a T12 led be used with a magnetic ballast?

As a side note, there is now a product that is actually compatible with both magnetic and electronic ballasts. So if you’re looking to upgrade T12 tubes to LED but you don’t want to replace all of the ballasts at once, the Philips UniversalFit tubes may be an excellent option to consider.

How to insert a tecnai sample into a microscope?

Open TECNAI USER INTERFACE; Open TIA. 4. Load Sample. Put sample onto chosen sample holder (single tilt; double tilt.) Observe O-ring under optical microscope and remove dirt and dust. To insert holder into microscope: – Align small pin on holder with large pin on goniometer and insert holder fully into microscope.

What are the start of session steps for tecnai?

Start-of-Session Steps 1. Add LN 2to ACD dewar. Check level during session. DO NOT allow to dry! 2. Log into Windows with your username and password. 3. Open TECNAI USER INTERFACE; Open TIA. 4. Load Sample. Put sample onto chosen sample holder (single tilt; double tilt.) Observe O-ring under optical microscope and remove dirt and dust.