How do you reset the oil light on a Toyota rav4?
Press and hold the Trip Meter stem. Continue to hold the Trip Meter stem button while turning the ignition back to the “OFF” position. Turn the ignition back to “LOCK“, then release the button. The “Maintenance Required” light should be cleared.
How do you reset the maintenance required light on a 2012 Toyota rav4?
How To Reset Maint Reqd Indicator Light On Toyota Rav4
- Turn on your car without starting.
- Make sure you are on TRIP A screen.
- Switch off the ignition.
- Hold down the ODO/TRIP button while turning the car back on.
- Keep holding it until you see zero and you’re done.
How do you turn off the AWD light on a Toyota rav4?
Here’s how it works. dash light will illuminate to indicate AWD is turned on. Press “Lock” again to turn it off.
How do you reset the oil light on a Toyota?
Put your key in the ignition and turn it to position one, the position just before starting the car. Push and hold the trip meter reset button on the dashboard, then turn your key to position two. Continue holding the odometer button for 10 seconds. The light should then flash, possibly beep, and then go out.
How do you reset the maintenance light on a 2009 Toyota rav4?
Just follow these simple steps:
- Put your key in the RAV4’s ignition.
- Push and hold the trip meter reset button on the dashboard.
- Hold the odometer button for ten seconds.
- Once the light goes out, release the odometer button and start the car.
Why is my AWD light on Toyota RAV4?
If Your check engine light and AWD lights are both on in Your 2015 Toyota RAV4 that usually means that there was a problem detected with the all wheel drive system. The all wheel drive system in this SUV does get information from the power control module though so there may not be anything wrong with it.
Can you drive with the AWD light on?
The AWD warning light illuminates when the ignition switch is pushed to the ON position. If the warning light blinks rapidly during operation, stop the vehicle with the engine idling in a safe place immediately. Then if the light turns off after a while, you can continue driving.
What causes the low oil light on a Toyota RAV4?
No Oil. The number one reason that your Rav4 would have low oil pressure would be a lack of oil.
How do I reset oil light after oil change?
Hold the button down until the “Oil” icon or word starts to flash, or the indicator lights show some other sign of resetting. Some cars will flash the word “Reset,” or display the numeral “100” to show that 100 percent of oil life remains after the oil change. Turn the ignition off, wait a few moments, and then start the engine.
How do you reset the maintenance required light?
Turn of Maintenance Required Light. Here’s what to do: With the car off and key out, hold in the odometer select/reset button. Insert the key and turn to the run position without starting the car. Keep holding the button in. The Maintenance Required Light will blink once and then in another 5-10 seconds.