What is an ATA hard drive?

What is an ATA hard drive?

Stands for “Advanced Technology Attachment.” It is a type of disk drive that integrates the drive controller directly on the drive itself. Computers can use ATA hard drives without a specific controller to support the drive. The term IDE, or “Integrated Drive Electronics,” is also used to refer to ATA drives. …

Is Ultra ATA the same as SATA?

Ultra ATA is essentially a parallel ATA type while SATA is obviously serial in design. Ultra ATA can be loosely considered as an IDE device while SATA is far from being considered as IDE since it is in serial. 3. In general, SATA has better performance based on data transfer rates.

Where can I get an Ultra ATA / 133 card?

Mac-compatible Ultra ATA/133 cards are available from companies such as Sonnet Technologies (www.sonnettech.com). Tools Required for Installation Small (#2) Phillips Screwdriver Small Needle-Nose Pliers Operating System CD and Boot Diskette Your System User Manual 2Connect Hard Drives

What kind of cable do I need for ATA / 133 card?

If you are connecting more than two drives to the ATA/133 card, you will need to connect a sepa- rate Ultra ATA cable to the IDE2 connector on the card. This cable is included with the Maxtor Hard Drive Mounting Kit, available from your local Maxtor retailer or www.maxstore.com.

How to connect psata IDE Ultra ATA 100 / 133 to SATA board?

Take the PSATA IDE Ultra ATA 100/133 To SATA Converter board and CAREFULLY line up the pins on the hard drive to the connector on the board. If your not careful with this alignment the board can be offset by one row of pins. 7. Plug-in the SATA cable on to your motherboard.

How big of hard disk do I need for ATA / 133?

ATA/133 connector to a classical 3.5″ hard disk (below) and a 2.5″ model (above) RECOMMENDED VIDEOS FOR YOU… Those who want to install a 2.5″ notebook hard disk in a typical desktop PC – if only for data synchronization – can use an adapter like this one.