How do you reset a system sensor?
The detector must be reset by the system control panel, front cover Test/ Reset button, or remote accessory. 4. To reset using the Test/Reset button on the power board cover simply press and release.
What does a system sensor do?
About System Sensor Founded in 1984, System Sensor is a global manufacturer of fire and life safety devices, specializing in smoke detection, carbon monoxide detection, and notification technology for world-wide applications.
How do you reset a smoke detector with a magnet?
Test/Reset Button – Press and hold the test button located on the power board cover for at least 2 seconds. M02-04-00 Magnet Test – Place the painted surface of the magnet onto the MAGNET TEST location on the sensor cover of unit.
IS system sensor part of Honeywell?
Engineered to the same high standards as all Honeywell offerings, the System Sensor line of products are reliable, sophisticated and designed for real-world applications. System Sensor products provide world-class fire and smoke detection for real-world applications all over the world.
Are wired smoke detectors low voltage?
Low-voltage hardwired smoke detectors are designed to be connected to a home security system’s control panel. Combined with fire alarm monitoring, this gives the best protection for both life and property. When low-voltage smoke detectors are added to a house, the 110-volt units should not be removed.
What are the notification devices?
The most common notification devices installed today are strobes, horn strobes, speakers and speaker strobes. Strobes provide synchronized flashes to alert the hearing-impaired occupants to evacuate the premises. Horn strobes combine audible and visual alarms to alert the occupants to evacuate the premises.
How do you clean a duct sensor?
To clean the duct smoke detector: Remove the detector’s cover then power down the detector by disconnecting the initiating device circuit wiring. 2. Using a vacuum cleaner, clean compressed air, or a soft bristle brush, remove loose dirt and debris from inside the detector housing and cover.
Do smoke detectors have magnets?
Smoke or Magnet? Smoke detectors usually have two ways of being tested. Smoke (smoke particles in the air, or some sort of canned smoke), and magnets (the activation of an internal magnetic reed switch).
What is fire alarm for?
Photo Cell is used in fire alarm to detect the smoke.