Is Linksys WRT54G outdated?
The WRT54G was a device for a different time. Indeed, its specs are pretty anemic by today’s standards. With Internet speeds increasing beyond 100 megabits, sometimes even to 1 gigabit, the Linksys WRT54G is obsolete in those cases. You’re wasting money on the faster Internet speeds.
How do I use my Linksys WRT54G as an access point?
Linksys Wireless-G Router (WRT54G)…Configuring an Access Point as a wireless repeater
- Access the router’s web-based setup page.
- When the router’s web-based setup page opens, click Status then click Wireless.
- Take note of the MAC Address.
- Connect a computer to the access point.
- Assign a static IP address on the computer.
When did WRT54G come out?
December 2002
The original WRT54G was first released in December 2002. It has a 4+1 port network switch (the Internet/WAN port is part of the same internal network switch, but on a different VLAN)….WRT54G.
| Version | 1.0 |
|---|---|
| CPU | Broadcom BCM4702 @ 125 MHz |
| RAM | 16 MB |
| Flash memory | 4 MB |
| S/N Prefix | CDF0 CDF1 |
What can I do with an old Linksys router?
We’ve identified 12 ways you can reuse an old Wi-Fi router:
- Guest Wi-Fi connection.
- Wireless repeater.
- Cheap internet radio.
- Use the old router as a network switch.
- Adapt it as a wireless bridge.
- Convert your router into a NAS.
- Use an old router as a web server.
- A DIY VPN router.
How do I make my Linksys WRT54G a repeater?
You can turn the Linksys WRT54GS router into a repeater bridge by resetting the router, updating the firmware, setting a static IP address on your computer, changing the router settings then resetting the computer IP address. This task can be complex and time-consuming; only advanced users should try it.
Who bought Netgear?
Nortel Networks
1996 Netgear is formed as a subsidiary of Bay Networks, Inc. 1998 Nortel Networks acquires Netgear.
How do I reset my Linksys WRT54G?
How can I reset the WRT54GS to factory defaults? Press and hold the Reset button at the router’s back panel for 30 seconds then release. Alternatively, use the web-based setup page, go to Administration tab > Factory Defaults sub-tab and click the Restore Factory Defaults button.