How do you turn off the anti theft system on a 2005 Chevy Malibu?

How do you turn off the anti theft system on a 2005 Chevy Malibu?

Reach in through the window and turn the key to ‘half I’m (as opposed to full on). Then leave it sit for 10 minutes until the anti theft light stops blinking. Then reach in through the window, take the key out fully, then re insert key and start car while standing outside.

How do you turn off anti-theft on Chevy Malibu?

Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.

How do I disable GM Anti theft system?

How to Disable a GM PassLock System

1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
2. Look at the dashboard and locate the theft system light.
3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

How do you bypass ignition security?

Reconnect the battery, insert the key into the ignition and start the vehicle. The vehicle should start, and then stall while the SECURITY light flashes. Leave the key at the ON position for 10 minutes and wait for the SECURITY light to go away. Turn the key to the OFF position for 5 seconds and restart the car.

How do you reset the anti-theft system on a Chevy Malibu?

Turn the ignition to the “On” position without starting the engine, and leave it on for 10 to 15 minutes. Turn the ignition off. Repeat the process two to three times. Wait one minute after the final attempt, and then start the car.

How do you bypass a Chevy security system?

In a chevy silverado, you will try to reset the anti-theft system by turning the key on until the yellow lock goes out on the instrument panel for about 10 minutes. Turn the key off and do it 2 more times after 3 cycles, pull the key and put it back in.

How do you disable the PassLock on a Chevy Malibu?

Turn on the car and let the vehicle idle. Turn the toggle switch to the “OFF” position. This disables the Malibu’s Passlock system. Pry the ignition cylinder trim ring off the dashboard using the trim tool.

When did the GM Pro bypass module come out?

At NEWROCKIES Inc., we’ve designed our PRO Bypass Module in 2008 with the specific purpose of bypassing faulty GM VATS, Passkey and Passlock security systems IN FULL.

How to replace the PassLock sensor on a GM car?

Find the three wires that connect the Passlock Sensor to the Body Control Module and substitute our circuit for the Passlock Sensor. Perform the “Relearn” Procedure so that our Body Control Module recognizes our new circuit. Go to Radio Shack and buy a Mini Terminal Block, and a package of 2200 ohm (2.2k-Ohm) resistors.

Is it possible to disable the PassLock on a car?

If you use any key besides the one programmed to the Vehicles to start the car, it will go into theft mode and disable the ignition system. While you cannot remove the Passlock system, you can disable it by tricking it into thinking the Vehicles had a malfunction.