How do you use an aero chamber?

How do you use an aero chamber?

Taking an Inhaled Treatment

1. Gently breathe out.
2. Put the mouthpiece in your mouth between your teeth and close your lips around it.
3. Press the inhaler once.
4. Breathe in slowly and deeply over 3 – 5 seconds.
5. Hold your breath for up to ten seconds.
6. Resume normal breathing.

Should I use a spacer with Alvesco?

To make sure your Alvesco inhaler delivers the correct dose you should clean it regularly as outlined in the instructions. The doctor may have advised that you use a spacer device with your inhaler. This is also recommended for children 6-11 years of age.

Do you have to use a spacer with an inhaler?

It is important for everyone to use a spacer each time they use their inhaler. A spacer is an attachment that fits onto the end of your inhaler. If you use your inhaler without a spacer, then most of the medicine ends up inside your mouth or stomach, instead of your lungs, where it works best.

Do you have to shake the Alvesco inhalation unit?

• Make sure the canister is firmly placed in the mouthpiece each time you use your ALVESCO Inhalation Aerosol. • You do not need to shake your ALVESCO Inhalation Aerosol unit before you use it. Using Your ALVESCO Inhalation Aerosol

How to use your Alvesco inhaler ( Ciclesonide )-2?

1. Remove Alvesco® cap. Place middle or index finger on top of canister and thumb underneath the mouthpiece of the inhaler. COPD QI Steering Committee How to Use Your Alvesco ® Inhaler (ciclesonide) -2-. 2. Breathe out fully (in preparation to breathe in medication).

How to use an aerochamber with a mask?

How to Assemble the AeroChamber® with Mask 1 Remove the cap from the mouthpiece on the inhaler. 2 Put the inhaler mouthpiece into the rubber-sealed end of the AeroChamber®. 3 Shake the inhaler and AeroChamber®. This mixes the medication properly.

How to use aerochamber plus flow-Vu inhaler?

Administer 1 puff at a time. Breathe out gently and press the MDI at the beginning of a slow inhalation as the Flow-Vu ® IFI moves toward you. Use the Flow-Vu ® IFI to count breaths. Maintain seal for 5-6 breaths after the MDI is pressed. Slow down inhalation if you hear the FlowSignal ® Whistle sound.