How much oil does WordPress forks take?

How much oil does WordPress forks take?

How much oil does WordPress forks take? Slowly squirt 10cc of oil into the forks. It is important to note that as the 10cc of oil goes in, 10cc of air must come out.

How much oil do you put in WP 4CS Forks?

The 4CS is filled not by volume but up to a level. The Alta 4CS oil level spec is 65mm from the top. You measure it with the spring removed and the fork fully bottomed out. The lower chamber needs to be filled completely full and then burped or bled.

How much fork oil should I use?

Slowly squirt 10cc of oil into the forks. It is important to note that as the 10cc of oil goes in, 10cc of air must come out.

How do I adjust my 4c forks?

Adjusting 4CS Fork Oil | How To

1. Step 2: UNDO FORK CAP. Undo the top fork cap and slide the outer fork tube down so you can access the spring.
2. Step 3: HOLD THE LOCKNUT.
3. Step 4: UNSCREW THE CAP.
4. Step 5: REMOVE SPRING.
5. Step 6: STEEL YOURSELF.
6. Step 7: SUCK IT UP.
7. Step 8: POUR IT IN.
8. Step 9: TEST RIDE.

What happens if you put too much fork oil?

Too much oil can cause your forks go “on block”. For example if you break hard and hit a speed bump at the same time then worst case scenario would be that one or both of the slider end cap breaks out “which results in death or serious injury” (as the manual states).

What oil do you put in dirt bike forks?

Maxima Hydraulic is the best fork oil for dirt bikes in 2020. You don’t just replace fork oil when you replace your seals, or when you think it’s “been a while”. Different weight fork oil, will literally change the way your suspension feels.

What’s the best tool for a WP 4860 Fork?

Special Tools Used 1. 50mm WP Dual Chamber Fork Cap Wrench 2. Compression Bolt Removal Tool – WP 4860 MXMA CC 3. Fork Seal Driver [48mm] 4. Bladder needle Although the needle mentioned above is one designed for this purpose, one can be made with some imaginationand a grease nipple. Try get a small hand pump with a low pressure guage.

What’s the difference between WP forks and KTM Forks?

Notes: The cheapest way to fine-tune the KTM’s WP forks is to raise and lower the fork-oil height to get the smoothest midstroke action without bottoming, which is why we lowered the oil height by 10cc. KTM’s forks come with different oil heights for each model.

Can You rebuild a KTM wp4860 mxma cc Fork?

This page combines a few sources to aid in the rebuild of a KTM WP4860 MXMA CC fork. If you are mechanically minded and can source your own motorbike parts tools and accessories and are prepared to take a chance at possibly being up for big dollars if it goes wrong, then do so at your own risk.