How do I find RAID configuration on Dell r740?

How do I find RAID configuration on Dell r740?

During the boot sequence, press F2 to boot to the System Setup Utility. In System Setup Main Menu, select Device Settings. In Device Settings, select Integrated RAID Controller 1: Dell PERC Configuration Utility. In the PERC Configuration Utility Dashboard View under Actions, click Configure.

How do I set up RAID Dell PowerEdge?

Procedure

1. Start or restart the Dell PowerEdge server.
2. Press Ctrl+R to access the Perc 6/I Integrated BIOS Configuration Utility.
3. To create a new virtual disk, press F2 and select Create New VD.
4. Select an appropriate RAID configuration from the RAID Level drop-down menu.

How do I create a RAID configuration?

To enable RAID, use one of the following methods, depending on your board model.

1. Go to Configuration > SATA Drives, set Chipset SATA Mode to RAID.
2. Go to Advanced > Drive Configuration, set Configure SATA As to RAID.
3. Go to Advanced > Drive Configuration, set Drive Mode to Enhanced and set the RAID option to Enabled.

What is the best RAID configuration for a server?

RAID 5 is by far the most common RAID configuration for business servers and enterprise NAS devices. This RAID level provides better performance than mirroring as well as fault tolerance. With RAID 5, data and parity (which is additional data used for recovery) are striped across three or more disks.

How do I find RAID configuration in Dell Idrac?

During the boot process you have to press the CTRL + R keys on your keyboard to launch the RAID configuration utility: Once this is done, you should see the following screen in the KVM: 5.

How do I check Dell RAID status?

The RAID Status (Dell) service monitors the state of the RAID controller only. To monitor the firmware version, use RAID Controller Firmware (Dell). To monitor the battery status of the RAID controller, use RAID Battery Status (Dell).