What does red light on MicroCell mean?

What does red light on MicroCell mean?

If you are seeing a red flashing light, that would mean that the MicroCell is failing to get the location check. But if the light is solid red, that would mean that there is some issue with the power outage and the MicroCell is unable to get the right power that it needs to be running properly.

How long does it take for MicroCell to activate?

90 minutes
The MicroCell may be activating or downloading new software. During the activation process, it can take up to 90 minutes for your MicroCell to complete activation.

How do I setup my AT MicroCell?

Activate & register

1. Write down your MicroCell’s serial number as you will need it for online activation and for future reference.
2. To activate your MicroCell, open a web browser, and navigate to www.att.com/microcell.
3. Locate and click Activate.
4. Tap the desired account type.
5. Click Next.

How do I know if my MicroCell is working?

Turn your cell phone off and then turn it back on. Make sure your 3G, 4G or 4G LTE cell phone is on the approved user list for your MicroCell. Go to att.com/MicroCell and manage your settings. YES: Your MicroCell is active and your device is connected successfully.

Why is MicroCell not working?

Network light – Restart your MicroCell by unplugging the power cord from the wall outlet for at least 10 seconds. It may take another 30 minutes for the network light to turn solid green. Network and GPS lights – Move your MicroCell to the place where it originally got a solid GPS light.

Why is my MicroCell not working?

How do I reactivate my MicroCell?

Plug your MicroCell into a power outlet with the AC power adapter.

1. The power light on the front of the device will light up right away. It can take up to a minute for the Ethernet light to stop flashing.
2. It can take up to 90 minutes for your MicroCell to fully activate, and it may restart.

How do I connect my microcell to my phone?

Connect your MicroCell to a power outlet with the AC Power Adapter. The Power light on the front of the device will come on immediately. Within a few minutes, other lights will flash as a GPS signal is located and software is updated. NOTE: Hold on to this manual; you’ll come back to it after you activate your device.

Where do I find the microcell user manual?

AT 3G MicroCell™ User Manual | Getting Started 10 11 Visit att.com/3GMicroCell-Activateand follow the instructions on the screen. You’ll need the following » Serial Number (S/N)–it’s on the bottom of the device or the box label. » Your AT wireless phone number/user name and password.

How to add an at & T 3G MicroCell number?

When they make phone calls, they will use their own minutes and service plan. To add an AT 3G cell phone number to your approved user list, go to att.com/3GMicroCelland manage your settings. What type of Internet service does the MicroCell need?

Can a microcell be used with a 3G cell phone?

The MicroCell only works with AT 3G enabled cell phones. • Restart your 3G cell phone. Turn your cell phone off and then turn it back on. Or, in your cell phone settings, access “Airplane Mode” and turn it on then off, or “Mobile Network Connection” and turn it off then on.