Is nitride a good barrel finish?
Nitriding does not change any dimensions, so it can be applied to finished barrels. Proper nitriding will make a chrome-moly barrel’s surface as hard as it can be made. Stainless barrels—which have otherwise been very difficult to toughen up against wear—also become much harder than normal once nitrided.
Is nitride coating good?
The real benefit of nitriding is that you get better corrosion resistance than chrome, on both the inside and outside, at a lower cost, without affecting accuracy. Remember, the surface of the bore alters its chemical structure to become a harder material.
What is nitride coated?
Titanium Nitride is an extremely hard, inert, thin film coating that is applied primarily to precision metal parts. Titanium Nitride (TiN) is the most common PVD hard coating in use today. TiN has an ideal combination of hardness, toughness, adhesion and inertness.
What is a nitride finish?
Nitriding is a heat treating process that diffuses nitrogen into the surface of a metal to create a case-hardened surface. These processes are most commonly used on low-alloy steels. They are also used on titanium, aluminium and molybdenum.
Which is better stainless steel or nitride barrel?
Nitride significantly increases the barrel life and corrosion resistance of “stainless” (which for barrel stainless steel is not rust-proof). Which is less expensive? Nitride is significantly less expensive and less time-consuming for making barrels.
Is nitride or phosphate BCG better?
On the basis of performance, nitride wins. For nostalga, phosphate wins. The battle between these two smooth finishes comes down to cost vs performance. Both are excellent finishes that are very hard, smooth and high performing.
Do nitrided barrels rust?
Nitriding barrels provides a massive gain in corrosion resistance, but no process is 100% rust-proof. Faxon always recommends the barrel is cleaned and dried as needed.
Which is better phosphate or nitride barrel?
What is nitride coating used for?
Titanium nitride (TiN) coating is wear resistant, inert and reduces friction. Use it on cutting tools, punches, dies and injection mold components to improve tool life two to ten times, or more, over uncoated tools.