How do I reset my Cisco 7960 phone?

How do I reset my Cisco 7960 phone?

1. Step 1 How to reset Cisco 7940 / 7960 IP phone to factory defaults.
2. Immediately press and hold # and while the Headset, Mute, and Speaker buttons begin to flash in sequence, release #.
3. Press 123456789*0# within 60 seconds after the Headset, Mute, and Speaker buttons begin to flash.

How do I setup my Cisco IP Phone 7960?

How do I configure my Cisco 7940/7960 for SIP service?

1. Press the Settings key. The Settings menu is displayed.
2. Highlight Status.
3. Press the Select soft key. The Setting Status menu is displayed.
4. Highlight Firmware Versions.
5. Press the Select soft key. The Firmware Versions panel is displayed.

How do I reset my Cisco IP Phone 7965 to factory settings?

Resolution/Steps

1. Unplug the power cable from the IP phone and then plug it back in.
2. While the phone is powering up, and before the Speaker button flashes on and off, press and hold the hash # key.
3. Continue to hold # until each line button (right of the LCD screen) flashes on and off in sequence in orange color.

How do I unlock my Cisco 7960 IP phone?

To get to the unlock config screen, press the “Settings” button, scroll down to “Unlock Config”, and press the “Select” softkey. You will now be asked to enter the password. The default password is “cisco”. As you need to enter this password via the numeric pad, it should be entered as 222444777722266.

How do Cisco IP phones work?

With VoIP, analog voice calls are converted into packets of data. The packets travel like any other type of data, such as e-mail, over the public Internet and/or any private Internet Protocol (IP) network. When evaluating, it’s worth noting that you can make or receive calls using landline telephones.

How do I reset my Cisco 8851 phone?

8841/8851 series desk IP phone

1. Unplug the Ethernet cable from your Cisco IP phone. Wait 5 seconds.
2. Plug the Ethernet cord into your phone.
3. The Mute button will light up.
4. The main phone screen will appear.
5. Press the Settings (gear) button -> Admins Settings -> Reset Settings -> All Settings.

How do I reset my Cisco phone 7841?

Factory Reset Cisco IP Phone 7841 (Using Keypad)

1. Unplug the phone’s LAN cable.
2. Wait 5 seconds.
3. Press and hold # button while plugging the phone back in.
4. Release the # button when the light on the handset blinks red 2 times.
5. Press 123456789*0# in sequence.