How do I change the boot device in OK prompt?

How do I change the boot device in OK prompt?

Change the Default Boot Device (ok Prompt)

1. Get to the ok prompt. See Accessing the ok Prompt.
2. Configure the boot-device parameter with the correct boot device. ok setenv boot-device boot-device. where boot-device is a valid device from which to boot.
3. Verify the change. ok printenv boot-device.
4. Reset the host. ok reset-all.

Where is boot disk in Solaris?

How to identify the boot device (primary and alternate) in…

1. In a general production environment you’ll find the OS root disk is mirrored to avoid any single point of failures.
2. ok> printenv boot-device boot-device = rootdisk mirrordisk.

How do I check my boot disk in OK prompt?

At the ok> prompt, use the show-disks command to view the available disks on the system and select the boot-device path that you checked before in first step at command line. Note that at OBP level the device path will be slightly different than the one you checked at the command line.

How do I exit OK prompt in Solaris?

Reaching the ok Prompt

1. Graceful shutdown.
2. Graceful reset of the control domain using the ILOM reset command.
3. Manual system reset.
4. The Break key or the equivalent ALOM system controller command pair: -> set /HOST send_break_action=break. -> start /SP/console -force.

How do I find my boot drive?

You can open up disk management with diskmgmt. msc and under the Status column look for the disk that has “Boot” in it.

What is OBP Solaris?

The Open Boot PROM(OBP) aliases in solaris SPARC environments are created to simplify the access to hardware devices using user friendly names. When viewed via the devalias command at the prom level, they are listed in the form of the alias name followed by the full hardware path to the device.

How do I get OK prompt in Solaris 10?

uadmin commands) as described in Solaris system administration documentation. If the operating system is already halted, you can use the start /SP/ console command without using set /HOST send_break_action=break to reach the ok prompt.

How do I get to OK prompt from SC?

The . sc Command

1. At the sc> prompt in ALOM, type the following command: sc> break -y.
2. At the ok prompt in OpenBoot PROM, type the following command: ok setenv auto-boot? fals e.
3. At the ok prompt, type the following command: ok reset-all.
4. At the ok prompt, type the following command:

What drive do I install Windows 10 on?

You can install Windows 10 by downloading a copy of the installation files onto a USB flash drive. Your USB flash drive will need to be 8GB or larger, and preferably should have no other files on it. To install Windows 10, your PC will need at least a 1 GHz CPU, 1 GB of RAM, and 16 GB of hard drive space.