How wide is an EH Holden diff?
The width is 1727mm across all variants. The length ranges from 0mm to 4521mm.
How wide is a Hilux diff?
The closest fit for an Escort is the Hilux 2WD diff from RN10, RN15, RN20 & RN25 models manufactured during the first half of the 70’s. Each of these has the same spring centres (940mm) and overall width (1350mm) as an Escort.
Are diffs interchangeable?
Yes, they interchange. The side gears may need to be retained depending on if the axle shafts are fine or coarse spline. The older ones have a coarse spline pinion shaft that is supposed to be weaker.
How long is an EH Holden wagon?
177.6 inches
| Holden EH | |
|---|---|
| Length | 177.6 inches (4511mm) |
| Width | 68.0 inches (1727mm) |
| Height | 58.2 inches (1478mm) |
| Curb weight | 2464lb (1118kg) |
What DIFF is in a VS Commodore?
VT series 2 onwards they fitted the BW80 diff, which has a larger crown wheel and pinion, and also different ratios. Parts from these are not interchangeable with the earlier BW78. the next option is to fit a full spool….Diff Widths.
| VN, VP | 1566 |
| VN, VP – Executive V8 | 1539 |
| VR, VS | 1577 |
| VT | 1673 |
How wide is a Toyota rear axle?
Toyota Axle Widths
| Vehicle models | Front or Rear | Width, WMS to WMS |
|---|---|---|
| Toyota pickup/mini and 4Runner | Rear axle | 58″ |
| Rear axle | 58.5″ | |
| Toyota pickup/mini 2 wheel drive | Rear axle | 56″ |
| Toyota T100 | Front axle | 65″ |
How wide is a Dana 44 front axle?
The Dana 44 came with axle tubes anywhere from 2.5 to 3-inch in diameter. The Dana 60 only came with one axle diameter of 3.125 inches, which is pretty big.
How wide is a HQ diff?
DIFF WIDTHS
| MODEL | mm |
|---|---|
| HQ, HJ, HX | 1555 |
| HZ | 1563 |
| WB | 1592 |
| COMMODORE |
What is a 9 inch diff?
The simple thing to note about nine-inch diffs is that they have no bolts on the rear cover. The term ‘nine-inch’ refers to the outside diameter of the ring gear, and the head is held in from the front by 10 bolts.
Are 80 series front and rear diffs the same?
Front diff rings are usually interchangeable with other front front rings, but rear ones are totally different. IE you can’t put an LSD rear ring into any front diff at all.
Are front and rear differentials the same?
The differential is an essential part of your car. In front wheel drive vehicles the differential is in the front and called a transaxle. In rear-wheel drive vehicles, the differential is in the back. Four wheel drive vehicles have differentials in both the front and back.
What’s the diff ratio on a Holden EJ / eh?
Now travelling further back in the car, make sure your tailshaft is the correct length, balanced, and you have good uni’s fitted. The diff however is another story. The banjo diff that the EJ/EH came out with has ratios varying from 3.89 to 2.78, and each ratio has its purpose, and you will have to find out which one suits your needs.
What are the specs of a Holden Holden?
Capacity: 2450cc 149 cubic inches (2.442 litres) Type: Conventional, watercooled four stroke, reciprocating piston type with 6 cylinders Configuration: Front mounted, longitudinal, inline Head: Pushrod and rocker actuated ohv with two valves per cylinder
How big is the diff on a Holden Commodore?
In general, diffs become wider with successive models. For instance, the Falcon’s diff grew from 1432mm in the XK-XM to 1557mm in the EF/EL, while Holdens went from 1384mm in FX/FJ to 1555mm in the HZ/WB. An obvious departure is VL to VP Commodores — they were narrower than HT to WB Holdens.
Can you get disc brakes from a Holden?
The other alternatives that you have is to fit a salisbury type diff from a later holden, which you can get in LSD a bit easier. You can get a Borg warner diff from a VN-VS Commodore, cheap to buy, gives you disc brakes, but the cost of the conversion is the same as a NINE INCH!!!