What is the purpose of the condenser in a breaker point ignition system?
The condenser absorbs the energy and prevents arcing between the points each time they open. This condenser also aids in the rapid collapse of the magnetic field.
What is the function of contact breaker in ignition system?
The purpose of the contact breaker is to interrupt the current flowing in the primary winding of the ignition coil. When this occurs, the collapsing current induces a high voltage in the secondary winding of the coil, which has many more windings.
Where are the breaker points and condenser connected in an ignition system?
The condenser is usually located inside the distributor, but sometimes is attached to the outside housing. It has a single lead that attaches to the points where the negative wire from the ignition coil attaches.
What is the purpose of a capacitor in an ignition system?
A Capacitor Discharge Ignition or CDI is an electronic ignition device that stores an electrical charge and then discharges it through an ignition coil in order to produce a powerful spark from the spark plugs in a petrol engine. Here the ignition is provided by the capacitor charge.
What does the condenser do?
The purpose of the condenser is to receive the high-pressure gas from the compressor and convert this gas to a liquid. It does it by heat transfer, or the principle that heat will always move from a warmer to a cooler substance.
What is the purpose of breaker point?
The breaker points control the flow of current through the primary of the coil and open and close approximately 150 times per second in a V-8-powered car traveling 60 miles per hour. Under such operating conditions, the points are closed for approximately 0.005 of a second for each spark created.
How do points work ignition?
Points. Ignition points are a set of electrical contacts that switch the coil on and off at the proper time. The points are opened and closed by the mechanical action of the distributor shaft lobes pushing on them. The points have a tough job, switching up to eight amps of current many times per second at highway speed …
Is a condenser a capacitor?
A capacitor (originally known as a condenser) is a passive two-terminal electrical component used to store energy electrostatically in an electric field. The forms of practical capacitors vary widely, but all contain at least two electrical conductors (plates) separated by a dielectric (i.e., insulator).
How do you check the condenser on a point ignition?
How to Test a Condenser in a Small Engine
- Remove the condenser from the engine.
- Switch the volt ohmmeter to the ohms position.
- Touch the red lead to the hot connector on the condenser.
- Remove the leads and reverse the placement to the condenser.
- Movement from the meter’s needle indicates the condenser is good.
How do you use a condenser?
Plug the small end of the cable into the microphone. Plug the other end of the cable into a USB port on your computer. Control the sound by launching your computer’s digital audio workstation (DAW). Turn the computer’s main output level down and switch the input and outputs to your microphone.
How does the contact breaker ( points ) ignition system work?
The ignition coil and condenser transform the battery current to high tension current which will jump the gap in the spark plug. The breaker points opens and closes the primary circuit at the proper time. The spark plug provides the means to fire the air-fuel mixture in the cylinder.
How are the points of a condenser ignition explained?
Points/Condenser Ignition Explained 1 The low-tension (primary) circuit, which generates the spark. 2 The high-tension (secondary) circuit, which delivers the spark to the relevant spark plug. More
How does a condenser work in a breaker?
The condenser acts as dampener at this point, preventing current from arcing (jumping) across the open gap in the breaker points, ensuring that the circuit is broken cleanly. Once the primary circuit is broken, the electro-magnetic field in the primary coil (1) becomes unstable and begins to collapse.
What do the breaker points and spark plugs do?
The breaker points opens and closes the primary circuit at the proper time. The spark plug provides the means to fire the air-fuel mixture in the cylinder. The wires connect the components together.