How do I silence my basement watchdog alarm?
To permanently disable the water fluid low alarm, attached the fluid sensor rod to the positive terminal of the battery. This can be done by tightening down the wing nut on top of the positive terminal and the fluid sensor.
How do I stop my sump pump from beeping?
If you just had a power outage and your backup sump pump was running, the alarm may go off temporarily until power is restored and it can recharge. If this is the case, some battery backup systems have a button to reset the alarm for 24 hours.
Can you recharge a sump pump battery?
Even a half-used battery can be recharged. The important point isn’t how much the battery is charged, but how much capacity it has. For example, the used battery may be able to power a load, but it will do so for a much shorter time than a new, unused battery.
Can I use a car battery with basement watchdog?
This DFK961 model system will work with a AGM/Maintenance free type battery. I would suggest making sure it has at least 75 Amp hours or higher. Be sure to connect the fluid sensor probe to the + (positive) post on the battery to disable the low fluid alarm.
Why is my battery backup alarm going off?
The alarm going off may be an indication of the failure of the primary sump pump. You can test this by checking whether the primary sump pump is still discharging water. You can tell by feeling the discharge line for the vibration of the primary pump. If the pump is not running, there will be no vibration.
How many years does a watchdog battery last?
A: The battery lasts anywhere from 3 to 5 years or so. The pump should last longer. You test it regularly and I would think about replacing from time to time, just for peace of mind.
Why is my basement watchdog beeping?
The first thing to do when you hear unexpected beeping noises from the basement or crawl space is to investigate and make sure there is no flooding. After that make sure the pump alarm goes off only in the event of flooding. Sometimes a beep from the pump may mean the batteries are low in the alarm.
What happens when a sump pump beeps?
When the sump pump starts beeping, it can be annoying, but it’s signaling to you that it needs assistance. If your sump pump battery is beeping, it is alerting you that it has lost power. However, if the power is on, it could mean that the water levels are low.
How do I reset my sump pump battery?
Reset the Battery Backup Sump Pump
- Step 1: Locate the Test Button. Locate the test button on the battery backup sump pump.
- Step 2: Inspect Inside of the Battery Backup Sump Pump. Check for any debris or clogs and make sure the pump is clean.
- Step 3: Restart the Battery Backup Sump Pump.
What voltage is a watchdog battery?
12 VDC
Battery Comparison
| Big Standby Battery | Maintenance Free/ AGM Battery** | |
|---|---|---|
| BATTERY BACKUP SYSTEM RUN TIME* | ||
| Depth | 6.75 inches | 6.5 inches |
| Weight | 50 lbs. | 50 lbs. |
| Voltage | 12 VDC | 12 VDC |
How often should I replace my watchdog battery?
A: The battery lasts anywhere from 3 to 5 years or so.
What kind of pump does basement watchdog use?
The Basement Watchdog® Big Combo CONNECT® is a pre-assembled energy-efficient 1/2 HP Cast Iron/ Cast Aluminum primary pump combined with the Basement Watchdog® Special CONNECT® Battery Backup Sump Pump System. In short, a no-assembly sump pump system is possible—with both primary and backup pumps!
How long did the glentronik basement watchdog pump last?
This pump lasted 1.5 years, never seemed to work quite right, and turned into an absolute piece of garbage at the end. The pump literally disintegrated in the sump and stopped functioning in less than 2 years (warranty for 1 year since Glentroniks knows this is an issue).
Is the bw4000 Big Combo connect still working?
Plus, Big Combo CONNECT® has high pumping capacity—up to 4,400 GPH on the main pump, so that you’ll know your basement will stay dry. This is the second BW4000 that I have had. The previous one lasted about 7 years. Actually it was still working when I replaced it.