How do I setup my Linksys VOIP phone adapter?

How do I setup my Linksys VOIP phone adapter?

Configuration

1. Obtain the ATA IP address.
2. Type the IP address into your web browser.
3. Once the page has loaded, press Admin Login then press advanced.
4. Go to the SIP tab.
5. Scroll down to RTP Parameters and sets RTP Packet Size to 0.020.
6. Scroll down to NAT Support Parameters and set Handle VIA rport and Insert VIA rport to no.

How do I reset my Linksys PAP2t?

Factory Reset Linksys PAP ATA

1. Connect an analog phone to any of the phone ports on the ATA.
2. Dial * four times.
3. Dial a special sequence 73738#. The ATA responds with “Press 1 to confirm or Press * to exit.”.
4. To confirm the factory reset dial 1.

Can a analog phone be connected to a Linksys pap2t?

An analog phone can be connected to each of the two phone ports and if enabled with your VoISP the Cisco/Linksys PAP2T will support both lines. Each phone port operates independently with separate phone service and their own phone numbers, line 1 and line 2.

How to use a Linksys VoIP adapter at home?

Just plug it into your home Router or Gateway and use the two standard telephone ports to connect analog phones or use one of the ports for a fax machine. Each phone port operates independently, with separate phone service and phone numbers, like having two telephone lines.

How to check the IP address of a Linksys router?

The Cisco/Linksys ATA can be accessed from connecting a PC and typing the IP address of the ATA into a browser. To determine the current IP address connect a phone into phone port 1 while the ATA is powered up and connected to your router’s LAN port and dial 4 stars **** then 110#.

Where are the Line 1 settings on Linksys spa1001?

Click on the “Admin Login” button near the top right side of the screen, then click on the “Line 1” tab. You need to modify only a few parameters from the factory default.