What is torque specs for 4L60E transmission pan?
4L60E Hardware Toqure Specifications
| Location | Quantity | Torque |
|---|---|---|
| Detent Spring to Valve Body Bolt | 1 | 24 N-m 18 lb-ft |
| Forward Accumulator Cover to Valve Body Bolt | 3 | 11 N-m 8 lb-ft |
| Solenoid Assembly to Case Bolt | 2 | 11 N-m 8 lb-ft |
| Oil Pan Bolt | 16 | 12 N-m 9 lb-ft |
What is the torque for transmission pan?
Setting the pan bolts to 12 foot-pounds of torque is only recommended after the pan is properly inspected and repaired.
How tight should tranny pan bolts be?
Pan bolts should be 8mm, probably 20mm long. Start the two rear bolts by hand using your socket. Do not run the bolts up too tight. If you drain the torque you should have drained most of the fluid from it so you can add all the recommended amount but for maybe a quart.
How many transmission pan bolts does a 4L60E have?
2. Trans filter and pan gasket (Make sure you get the right one. 4L60E square pan 16 bolts.
Do I need a torque wrench for transmission pan?
Even the cheap Harbor Freight torque wrench is a must for anyone doing anything with a pan but doesnt need a professional one. Over tighten the bolts and they will strip. Under tighten and it will leak. Dont tighten evenly and it will leak.
Do I need to torque transmission pan bolts?
We should always tighten transmission pan bolts to the specified torque, when we install them. This is done with a torque wrench. If we use this method, the torque on the bolts are correct. If the installer did not use a torque wrench, odds are the bolts are too tight already.
How many quarts does a 4L60E transmission hold?
The fluid capacity of the 4L60e is 12 quarts of transmission fluid (dry). This amount is based on a stock, “shallow” transmission pan with a 12″ torque converter. With a deep pan, the capacity of additional fluid can vary from an extra quart or more.
Do I have a 4L60 or 4l80?
Appearance. The 4L80E can be told apart from the 4L60E by looking at their transmission fluid pan. This is because the 4L80E has a pan that is oval in shape whereas a rectangular pan is featured by the 4L60E. Specifically, there is a gasket of 17 bolts on the 4L80E, while the 4L60E’s pan has 16 bolts.