What does the Cisco bandwidth command do?

What does the Cisco bandwidth command do?

The bandwidth command sets an informational parameter to communicate the current bandwidth to the higher-level protocols. IGRP uses the minimum path bandwidth to determine a routing metric. The TCP protocol adjusts initial retransmission parameters based on the apparent bandwidth of the outgoing interface.

How do I change the interface bandwidth on a Cisco router?

Steps to configure interface speed through CLI.

1. Login to the device using SSH / TELNET and go to enable mode.
2. Execute Show interface command to view the interface configuration.
3. Go into the config mode.
4. Go into the interface config mode.
5. Configure Speed.
6. Configure Duplex.
7. Exit interface configuration mode.

How do I change bandwidth in OSPF?

To adjust the reference bandwidth, use the auto-cost reference-bandwidth Mb/s router configuration command. This command must be configured on every router in the OSPF domain. Notice that the value is expressed in Mb/s; therefore, to adjust the costs for: Gigabit Ethernet – auto-cost reference-bandwidth 1000.

How do I check my bandwidth on my Cisco router?

Router interface bandwidth

1. Router#sh int GigabitEthernet0/0.
2. Router#sh run int GigabitEthernet0/0.
3. bandwidth 10000.
4. Router#sh int GigabitEthernet0/0.2015.
5. Router#sh run int GigabitEthernet0/0.2015.

How can I increase my bandwidth on my iPhone?

How to Make Data Faster on Your iPhone

1. Start by clearing your browsing history.
2. Optimize your hardware.
3. Keep your iOS up to date.
4. Turn off Background App Refresh.
5. Reboot your phone.
6. Check for a software update.
7. Install a Speed Boosting App.
8. Enable Text Mode in browser.

What is the bandwidthcommand command in Cisco IOS?

This command first appeared in Cisco IOS Release 10.0. The bandwidthcommand sets an informational parameter to communicate the current bandwidth to the higher-level protocols. IGRP uses the minimum path bandwidth to determine a routing metric.

How to set tunnel bandwidth in Cisco IOS?

tunnel bandwidth. To set the transmit bandwidth used by the tunnel interface, use the tunnel bandwidth command in interface configuration mode. To restore the default setting, use the no form of this command.

How to restore default bandwidth values in Cisco?

To communicate the bandwidth value of an interface to the higher-level protocols, use the bandwidthinterface configuration command. Use the noform of this command to restore the default values. bandwidthkilobits no bandwidth

How to upgrade Cisco IOS before upgrading Cisco IOS?

How to upgrade Cisco IOS Before upgrading IOS, you need to obtain the latest IOS version. This is usually done by logging in at https://software.cisco.com/ and selecting your device type and version. The downloaded file must then be transferred to a flash drive of the device, usually via TFTP or FTP.