Why is my Schlage lock blinking green?

Why is my Schlage lock blinking green?

Flashing green Schlage button after entering a code: The code entered is correct. Flashing red Schlage button after entering a code: The code entered is incorrect.

How do you reset a Schlage keypad lock?

So first how to Reset Schlage Keypad lock?

1. Disconnect the batteries.
2. Press and hold the Outside Schlage Button.
3. While holding the Outside Schlage Button, Reconnect the batteries.
4. Release the Outside Schlage Button.
5. To check that the lock was reset, press the Outside Schlage Button and enter one of the Default User.

Why is my Schlage lock blinking orange?

Orange flashes indicates lock is in the middle of a programming sequence.

How do you unlock a Schlage keypad lock with a dead battery?

How do you unlock a Schlage Control lock that has a dead battery?

1. Touch a new high-quality alkaline 9-volt battery to the contacts below the bolt throw.
2. Wait for 1 red light and then 3 green lights with 3 beeps.
3. Present a valid credential.
4. Rotate the bolt throw away from the door edge.
5. Replace the batteries.

How do you unlock a Schlage keypad lock?

When the battery is completely dead, you can use Key Override to unlock your Schlage keypad lock. To unlock using Key Override: Insert Key. Rotate key 270 o to unlock. Rotate the knob/lever to open the door. Note that the key cannot be removed from the cylinder while the lock is unlocked. Insert the key into the cylinder.

What to do when your Schlage Lock is dead?

When the battery is completely dead, you can use Key Override to unlock your Schlage keypad lock. To unlock using Key Override: Insert Key. Rotate key 270 o to unlock. Rotate the knob/lever to open the door.

Why is my door not opening with Schlage?

In a usual scenario, your door is supposed to open when you enter your code. If your lock blinks green light but still does not open, there might be some technical issues. According to Schlage, an incomplete or incorrect installation may cause your lock to not open even after entering a valid code.

Why is my Schlage deadbolt not working properly?

Sometimes, your Schlage deadbolt could open by the mere press of the button even though you already have a user code set up. The biggest cause of this problem is an installation error. The issue happens when you don’t follow the right procedure when assembling the lock onto the door.