What does E 21 mean on a tumble dryer?
Error E21 usually means excess water left in condenser or condenser pump not working/pumping to the reservoir. This can be due to wet condenser and/or blocked/faulty pump. Unplug the appliance and remove the condenser, clean the area and let the condenser dry for a while. Then plug it back after around 30 minutes.
Why does my Hoover dryer keep cutting out?
So What’s the Problem? Your Hoover tumble dryer keeps cutting out – It’s possible that you’ve overloaded the machine. Try removing some of your laundry and running the cycle again. However, the most common reason for a tumble dryer to cut out is that the thermal switch has tripped.
What does eo5 mean on my tumble dryer?
The e05 error indicates there is an issue with the NTC (the water temperature sensor at the back). It may be as simple as a loose connection which needs reconnecting.
What does E14 mean on a dryer?
E14 error code indicates Rear NTC detected faulty you will have to check rear NTC/thermistor…check the connections and wiring from the NTC …
What does A10 mean on a Hoover dryer?
What may look like ‘A10’ in the display is in fact AIO which means All In One cycle has been selected. If this is not the chosen programe then simply swich the control to another programe selection.
What does code E21 mean?
Error code E21 signifies a memory parity failure and is one of more frequently seen error codes on Series One and Series One Junior PLCs.
Why does my dryer stop running after a few minutes?
Drum Belt. The most common cause of a dryer shutting off after a few minutes is a broken or faulty drive belt. The drive belt goes around the dryer drum, idler pulley, and the motor pulley and helps the dryer to rotate when operating. If it is defective, the dryer won’t work correctly.
How do I reset E05 error?
Hold down the Stop/cancel or Reset button for about 10-15 seconds. If this doesn’t solve the error, the cartridges are empty. E5/E05: The printhead isn’t (correctly) installed or it’s broken. Open the cover of your printer and check whether the printhead is installed correctly.
What is rear NTC on Hoover tumble dryer?
The NTC sensor is normally fitted to the hot air fan duct. This sensor consists of a resistor contained in a metallic. capsule. Its resistance decreases as the temperature increases. The electronic circuit reads the resistance (which varies with the temperature inside the dryer); when this.
What does E08 mean on a Hoover tumble dryer?
E08 on your dryer indicates the overheat thermostat on your machine has tripped.
Clean all filters and check the condenser too. If it’s full or blocked this can be detected as an airflow problem. E08 – Hoover tumble dryer error code e08 is what you’ll see if there is a problem detected with the thermal fuse or its wiring.
Is the Hoover tumble dryer a condenser dryer?
Hoover condenser dryers are becoming an increasingly common feature in people’s homes, but unfortunately, this means more are experiencing some of the problems that can come with this type of tumble dryer. What Is a Condenser Dryer? Condenser tumble dryers are common for one simple reason – practicality.
What is the error code on my Hoover dryer?
The E4 error code is a faulty program selector. This could be just a temporary blip, so turn the machine off and on again, and try selecting the cycle again. If that doesn’t work, give Hoover themselves a call for advice. The E5 error code is regarding the temperature sensor.
What does ER 02 mean on a Hoover?
Er 02 – Debris is trapped or tangled around the agitators. Inspect and clean them Er 04 – Left drive wheel has become overloaded. Check that debris has not been tangled around it.