How do I find the model number of my YORK furnace?
For York, you should look for first two numbers in the model number. They are divisible by 6 or 12, which represent the nominal BTU of the system in thousands. A ton of air conditioning equals 12,000 BTU, and 48 divided by 12 equals 4, so the data plate below indicates the system is 4 tons.
What does a blinking red light mean on a York furnace?
Taking it from the top, if you happen to see 1 red colored flash on your York Furnace, it signals that the gas valve isn’t receiving power. You may have a gas leak at the valve. 2 red colored flashes means that the switch that controls pressure is possibly stuck.
What does 3 blinks on a furnace mean?
air pressure switch
What it means: Have you ever looked at your furnace and thought what do 3 flashes on American Standard furnace mean? This error occurs when the combustion air pressure switch that monitors the flow of air through the vent system fails to close while the induced draft motor is operating.
How do I reset the code on my furnace?
Most modern gas furnaces can be reset by turning off the power, waiting around 20 seconds, then switching the power back on. Other furnace models may exit lockout after 1-2 hours and attempt to power on again. If your furnace has a pilot light, you may need to relight it following the manufacturer’s instructions.
How do I know what kind of furnace I have?
Your furnace should have a sticker located someplace on the exterior or interior paneling. If you don’t see a sticker with the model and serial number on the outside, find where the paneling opens up and check if it’s located inside that door. Write down—or take a photo of—the serial number for reference.
How do I read my YORK model number?
How do I decode York serial numbers?
The second style of serial numbers are for York AC units that were manufactured before 2004. This style of Serial Number is formatted with four letters at the beginning of the sequence. The second letter is the month of manufacture and the third letter is the year of manufacture.
Should my furnace light be blinking?
When your furnace light flashes, that’s just another way it’s trying to communicate with you that there is a problem. When you see a flashing light, your furnace is sending you an error code. Check your circuit breaker box to see if you tripped the breaker for the furnace.
Where is the fault code on a York Furnace?
Hunker may earn compensation through affiliate links in this story. Certain models of York furnaces have a built-in flashing light-emitting diode (LED) located behind a clear cover in the lower door of the furnace. This LED flashes a fault code in a series of green, amber or red light flashes to signal normal operation or system problems.
What kind of Control Board does a York Furnace use?
S1-03101280000 York Package Unit Control Board (obsolete with no replacement available from York) S1-1474-0061/A Robertshaw Evcon Ignition Control (Used in Coleman Evcon, York Furnaces (Also found in some Lennox furnaces and some Rheem water heaters)
Why does my York Furnace not heat properly?
The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat. Few appliances are more important than a furnace, especially in the northern states. Repair Clinic understands this, and we strive to make sure your York furnace runs reliably and efficiently.
Where can I find replacement parts for my furnace?
Just be sure to enter the full model number of your furnace in our website’s search bar to find the specific replacement part you want. If you need additional help finding the right part, you can always call our Customer Service Team at 1-800-269-2609.