How do you reset your electric scooter?
If the scooter is over loaded, the circuit breaker may trip and shut off power to the motor. Correct the riding condition that caused the over load, wait a few seconds, and then push the reset button to reset the circuit.
Why will my scooter not start?
Check the Engine Ignition and Fuel System: In most cases, the problem with a scooter not starting but with power is caused by an issue with the engine; either a bad spark plug wire, bad plug or a fuel system problem. This is caused by a problem with the spark plug, spark plug wires, or the ignition coil.
Why is my e scooter not working?
If the electric scooter does not run check the motor because the motor is the power source. Because of excessive riding or doing stunts may cause the problems. Check the battery charger too. If the indicator does not work properly change the charger and then try again.
Where is the fuse located on an electric scooter?
All electric scooter have a fuse or a circuit breaker. Circuit breakers are usually on the outside of the scooter. Fuses are usually located on the outside of the scooter or under the footplate in the wiring harness near the battery pack.
Where is the reset button on a Go Go scooter?
When the scooter is running on a low battery, the main circuit breaker may trip to prevent damage to the motor and electronics. Naturally, all the electrical systems go offline when the breaker trips. This will cause the reset button to pop out at the rear section of your scooter.
How do you jumpstart an electric scooter?
Kick-Starting Your Scooter Locate the center stand on the bottom of your scooter. Stand on the left side of the scooter and hold the left leg of the center stand on the ground using your foot. Grip the handle bars on both sides with your hands and forcefully pull back and up to place the scooter on its center stand.
How do you reset the breaker on a scooter?
Circuit breakers are usually on the outside of the scooter. Fuses are usually located on the outside of the scooter or under the footplate in the wiring harness near the battery pack. If the scooter has a circuit breaker press the reset button to see if it will reset.
Why does my new scooter won’t start?
Probably the most common problems are a dead battery or carburetor problems due to bad adjustment or build up of gummy deposits. Carburetor problems usually come on slowly though. If a scooter is OK one day and refuses to start the next day, I’d first suspect an electrical problem.
Why is my mobility scooter not working properly?
Your mobility scooter might not have any battery problems at all. It might be something simple that is what stops the scooter from working. Without you even realizing it, the kill switch on your scooter is what is causing the trouble.
How do you start a electric moped scooter?
Start a moped / scooter with electric button Turn ignition switch to the on position. Make sure the kill switch is on the on position. Press both brake levers. As brake levers are press in press the starting button at the same time. The engine should turn over and start the vehicle.
What to do if your electric scooter loses power?
If your scooter shuts off at random or loses power during use, resetting the scooter can solve the problem most of the time. This also works when the power switch does not illuminate. Most scooters like the Phaewo electric scooter got a reset button that works in the following way: Place your electric scooter on a level, flat surface.