Can I move a washer without shipping bolts?
It is not recommended that you move front load washers without shipping bolts, and it can damage the machine. Remove the drain hoses and power cord, wrap the machine with dolly straps, and load it onto a hand truck or dolly for transport.
What size are shipping bolts on a washing machine?
They are typically 4 to 12 in (100 to 300 mm) in length, although any size is possible as it depends on the type of device being transported. The most common example of transit bolts is the securing of the drum of a washing machine while it is transported from shop to property (or property to property).
Are all washing machine shipping bolts the same?
Insert the shorter shipping bolts into the top bolt hole openings. Some brands of washing machines may have shipping bolts that are all the same length, and any shipping bolt can be used in any hole.
How do you secure a washing machine drum for transport?
Preventing a washing machine’s drum from excessive motion during your move will protect the suspension from breaking. You can do this by securing the drum with shipping bolts or transit bolts. These metal rods are inserted into special slots in the rear of the washer to secure the drum.
What is the best way to lift a washing machine?
The best way to pull a washing machine out, is to open the door and get hold of the door opening at the top of the door seal. Then lift the washing machine up and pull it forward on its back feet. But don’t rush in because there are potential complications you need to avoid.
What happens if you move a washing machine without transit bolts?
Moving a washing machine without transit bolts will run the serious risk of damaging your machine, so we strongly advise against it. However, you must remember to remove the transit bolts once your move is complete, as they can seriously damage your machine should you begin a wash cycle with them still in place.
Can leaving transit bolts damage washing machine?
The bolts can rip sections off the outer tank, tear through the outer casing and cause massive damaging vibrations to be sent through the room in which the washing machine is installed. In other words, by not doing as instructed you risk major damage to your washing machine.
Is it OK to transport a washing machine on its side?
It’s recommended you always keep a washing machine in an upright position. Laying a washer on its side can cause the inner and outer tubs to bump against each other, which can loosen support pads or damage the suspension. It can also cause the tubs to move out of alignment and alter the way your unit works.
Will a washing machine work with transit bolts?
Where are the shipping bolts located on a Whirlpool washer?
The bolts attach on the rear of the appliance. This is a universal accessory that can be used across several brands; check to see if your model number is compatible.
What kind of bolts do you get at Lowes?
Choosing the correct bolts for your project is easy at Lowe’s. Hex bolts are used in machinery and construction. These bolts can be partially or fully threaded and are paired with a washer and nut or in a tapped hole. Carriage bolts have a smooth, rounded head with a square section underneath the head.
What do you use a hangar bolt for?
Hangar bolts are used to position overhead fixtures into wood beams and joists. Split bolts are a specialty item used to make copper-to-copper wiring connections.
How big is a drip pan for a washer?
Washer Drip Pan With LAD- 32 In. x 30 In. x 2.5 In. – Galvanized Steel Compact Front-Load Drain Pan With LAD- 27 In. x 25 In.