How do I identify my rear axle?
It’s worth noting that rear axles can sometimes be positively identified by a casting number and date stamped on the differential cover or axle tube. However, road debris, dirt, grime, and general age can obscure these numbers.
How do I identify my Eaton rear axle?
Model Identification Axle Housings are identified by the specification number stamped on the rear right hand side of the axle housing. This number identifies all components of the axle as built by Eaton, including OEM special requirements such as yoke or flange.
How do I identify my Dana 80 rear axle?
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a “80” cast into the housing.
How much is a rear end axle?
The average cost for axle shaft replacement is between $916 and $957. Labor costs are estimated between $155 and $195 while parts are priced at $762. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
How do I tell what axle I have?
Stamped Number on the Axle To figure out exactly what axle you have, you can look for the Dana stamped bill of materials number. This stamped number can usually be found on the righthand side or on the longer axletube on the same side of the tube as the differential cover, facing the rear of the truck.
How does a 2 speed rear axle work?
The 2-speed axle works on the same basic principles, but with an added planetary gear set inside the ring gear. This works by sliding a clutch gear meshing with the high range clutch plate. When the low range is selected, the sliding clutch gear engages with the low range clutch plate.
Is a Dana 80 a 1 ton axle?
The Dana 80 is just a Dana 70 with disc brakes. The Dana 70 or 80 is great for a 1 ton truck but not a 2.5 ton truck.
What is the difference between Dana 70 and 80?
On the 2500, the only difference between the 70 and the 80 is the ring gear size. The 70 has a 10. 5″ ring gear, the 80 has an 11″ ring gear. The axle shafts, brakes, and hubs are the same.
Does a broken rear axle total a car?
If you suspect that your axles are about to break, bring your car in for service right away. Once broken completely, your car won’t move and, if they break while you’re driving, you could end up with a totaled car.
What kind of engine does an international S1900 have?
Stock ID #W4305 1981 INTERNATIONAL S1900, (odometer reading 64,078), Diesel motor, 10 speed manual trans, 28,000 gvw rating (9K F/19K R), Air Brakes, dual fuel tanks, power steering, air seat and…
How much is a 1984 International S1900 truck?
FINANCING AVAILABLE! 1984 International S1900 Cab & Chassis $6900 DT360 Engine 5 Spd Transmission w/ 2 Spd Rear 463k Miles 184″ Wheel Base 176″ Cab to End Frame 116″ Cab to Axle 28k lb G… See More Details 6900 HRS. Enter search information and click the Search button below.
How big is the International S1900 livestock truck?
International S1900 livestock truck. This truck is showing 340651 miles on it. It has a steel livestock rack on it that measures approximately 8’x24′ and has 2 divider gates. It has a roll up center gate for loading.