Which command is used for verifying and troubleshooting problems?

Which command is used for verifying and troubleshooting problems?

The following three commands are used to verify and troubleshoot RIP:

• show ip route.
• show ip protocols.
• debug ip rip.

How do I enable RIPng?

To declare a RIPng process name, use we use “ipv6 router rip ” Cisco IOS command from the global configuration mode. RIPng uses the interface configuration mode command “ipv6 rip enable” to add an interface to a RIPng process.

What is RIPng protocol?

The Routing Information Protocol next generation (RIPng) is an interior gateway protocol (IGP) that uses a distance-vector algorithm to determine the best route to a destination, using hop count as the metric.

Is RIPng a dynamic routing protocol?

The RIP (Routing Information Protocol) is a distance-vector dynamic routing protocol that is used by the appliance to automatically configure optimal routes based on messages received from other RIP-enabled on-link hosts (typically routers).

What is the basic troubleshooting commands?

You can run common network troubleshooting commands such as arp, ping, ping6, traceroute, traceroute6, NSlookup, and AvgRTTs from the admin console. You can use these connectivity tools to see the network path from the system to a specified server.

What is Ripng IPv6?

IPv6 RIP is an Interior Gateway Protocol (IGP) designed to manage a relatively small network. IPv6 RIP is based on the Bellman-Ford or the distance-vector algorithm. A IPv6 RIP router broadcasts routing information to its directly connected networks every 30 seconds.

What is RIPng IPv6?

What multicast address does RIPng use?

FF02::9
RIPng uses the multicast address FF02::9, the all RIP routers multicast address, as the destination address for RIP updates. RIPng updates are sent on UDP port 521.

Is the Rip process a classless routing protocol?

The RIP process now includes the subnet mask in all updates, making RIPv2 a classless routing protocol. Configuring version 1 enables RIPv1 only, while configuring no version returns the router to the default setting of sending version 1 updates but listening for version 1 or version 2 updates.

How to enable rip in router configuration mode?

To enable RIP, use the router rip command to enter router configuration mode, as shown in the following output. This command does not directly start the RIP process. Instead, it provides access to the router configuration mode where the RIP routing settings are configured. R1# conf t Enter configuration commands, one per line.

How to tell if Cisco router is running rip or RIPv2?

Go to the online course to use the Syntax Checker in the third graphic to verify the R2 and R3 RIP settings and routes. By default, when a RIP process is configured on a Cisco router, it is running RIPv1, as shown in the following output: However, even though the router only sends RIPv1 messages, it can interpret both RIPv1 and RIPv2 messages.

Are there security risks with Rip and RIPng?

Security risk: Advertising updates on a broadcast network is a security risk. RIP updates can be intercepted with packet sniffing software. Routing updates can be modified and sent back to the router, corrupting the routing table with false metrics that misdirect traffic.