What is an airtronic heater?

What is an airtronic heater?

Eberspaecher (ESPAR) Climate Control System’s Airtronic air heaters operate like forced air furnaces utilizing the vehicle’s own fuel and power supply to produce heat without idling the vehicle.

How do I reset my Eberspacher heater?

Also how to perform an Espar heater reset….For Airtronic D2/D4 heaters using the DIGI-DIAGNOSTIC TOOL/CONTROLLER:

1. While in diagnostic mode push and hold both arrow buttons until “EE” is displayed on the screen.
2. To exit diagnostic mode hit the ON / OFF button.
3. To shut the unit down hit the ON / OFF button again.

Why is my diesel heater not working?

The most likely causes of heaters not starting is no fuel, insufficient power or no air flow. Please follow the steps below to check these issues. Remember to reset the heater between starting attempts by removing and replacing the fuse.

How do you service an Eberspacher heater?

Eberspacher recommended service schedule Clean fuel screen in glow plug port with a soft brass brush. (Note position of screen proir to removal). Check for blocked or damaged ducting and rectify or replace as required. Inspect intake and outlet grilles for blockages; also inspect intake fan blades for any restriction.

How do I prime my Espar heater?

PRIMING THE FUEL LINE Just disconnect the power to the heater via the fuses, wait a few seconds, then reconnect the power. You may need to do this 4-5 times before the heater is fully primed and kicks on.

How do I test my Eberspacher heater?

Check voltage on heater’s harness on the heater’s side (pins 1 and 10 on Airtronic connector). Turn the heater ON and make sure that the voltage is still OK. Repair harness and connections if necessary. Being turned on, heater just blows cold air, never stops and never performs a start attempt.

How do I reset my diesel heater?

Remember to reset the heater between starting attempts by removing and replacing the fuse. Check your batteries are fully charged, connect to power or put a battery charger on them to rule out low battery voltage as the issue.

How do I service my diesel heater?

Periodic maintenance is vital for ongoing diesel heater efficiency. The key elements of a diesel heater service are to clean or replace the glow pin and to remove any carbon deposits from the combustion chamber, replacing it if necessary. The fuel filter should also be replaced, and fuel and exhaust lines checked.

Is the eberspacher D2 a good diesel heater?

The Eberspächer D2 diesel heater is designed for recreational vehicles of every type. Offering smooth automatic room temperature control and energy efficient operation. Offering automatic room temperature control, the energy efficient Airtronic Diesel Heaters allow you to set and forget.

How much power does an eberspacher air heater have?

Make sure this fits by entering your model number. Diesel fired air heater with 2.2 kW 7500BTU heating power. Automatic altitude adjustment – up to 3000m above sea level. No additional altitude kit required. Get a better nights sleep, with the new stepless motor and silent fuel pump.

How to turn on Airtronic d2 / d4 + heater?

Press “Instant On / Off” key to activate heater, the “Green LED Indication Light” will illuminate and the blower motor will start and hot air will be delivered in approximately 120 seconds from switch on. To select the temperature press the “Up” or “Down” key and hold until the desire temperature is displayed.