What is the difference between myford ML7 and Super 7?
The Super 7 has a much better (higher) speed range with spindle bearings to cope, more powerful motor as standard, a self ejecting tailstock, clutch, longer cross slide, better top slide with full 360 degree rotation, etc, etc. Also power cross feed with the later machines.
How heavy is a myford ML7 lathe?
Manual says 365 lb for the Lathe and cabinet stand. 245 lb without cabinet (both with motor.
Are myford lathes metric?
For customers who own an Imperial Myford ML7, ML-7R or Super 7 lathe, with a Quick Change gearbox later than 1956, Myford offer a metric conversion set Part No 1481/1 to enable a full range of metric threads to be cut ranging from 0.2 mm pitch through to 4.00 mm pitch.
What happened myford lathes?
Over the years Myford’s small lathes – especially the Super 7 model – have been used loyally by enthusiasts to make models such as miniature boats and locomotives. But last weekend, the company announced it was in liquidation. They said due to the recession and cheaper foreign imports the business was being wound up.
Are myford lathes still made?
Myford Ltd was founded by solicitor Jonathan Oxley with an original name of L & P 240 Limited. The name was changed to Myford Ltd on 26 August 2011 and continues to run from its base in West Yorkshire, where lathes are still built and refurbished.
How big is a myford ML7?
An ML7 is around 42″ long and occupies a space about 22″ front to back while a Super 7 is approximately 46″ long and a little deeper than the ML7 at around 27″.
Who owns myford?
As of 2010 the business was still owned by the family, and run by Moore’s grandson Christopher Moore. During mid-July 2011 Myford announced a “liquidation sale” stating that it would be last opportunity to buy “spares, lathes and plant equipment” from Myford themselves at the Beeston site.
Where are Colchester lathes?
A positive air is immediately apparent at 600 UK’s reconfigured and refurbished Heckmondwike, West Yorkshire facility (01924 415000), where Colchester and Harrison lathes, as well as Pratt Burnerd workholding products, are manufactured, assembled, supplied and supported.
Who owns myford Ltd?
As of 2010 the business was still owned by the family, and run by Moore’s grandson Christopher Moore.
Are there spare parts for MyFord ML7 lathe?
In this section are a selection of Myford ML7 new and used spare parts, although some spares will also fit other makes and models of lathe.
Is the MyFord ML7 based on a MyFord Super 7?
Please note that in later years Myford produced a lathe they named the ML7-R, this lathe wasn’t actually based on the ML7 at all as the name may imply, but was in fact based on the Myford Super 7, so most parts for this lathe can be found by looking under the Super 7 section.
What kind of belt do I need for my ML7 lathes?
Standard Vee-Belt which drives from the 3-step pulley on the countershaft to the headstock spindle drive pulley.This belt is also suitable for ML7 lathes fitted… Standard Vee-Belt which drives from the 2-step pulley on the motor to the countershaft drive pulley.High quality belt from a major supplierApplication: Super 7;…
Which is MyFord attachment for Super 7 lathes?
MYFORD Turret Attachment for ML7 and Super 7 Lathes (Accessory 1408). Instructions and Drawings for Drilling and Reaming the holes in the turret head. MYFORD VM-A Milling Attachment – made by Rishton (sold by them using Model Codes VM602 and VM452). Operator’s Instruction and Maintenance Manual with Parts as Sectional drawings.