What is a patchbay used for?
What is a patchbay? An audio patchbay connects all of the inputs and outputs of your outboard gear into a centralized hub. This allows you to route one device to the next without needing to go behind a rack full of gear in order to change one thing.
What is half Normalled Patchbay?
A half-normal patchbay configuration is commonly used with analog line level signals. The signal from the source device, at the top jack, flows through to the jack directly below, to a destination device, via the “half-normal” signal route. The signal can then be re-routed, as required, in the signal chain.
Do you need a patchbay?
That allows you to route and insert compressors and EQ’s into your mix. If you are using an analog console in your setup, the patch bay is a must to properly send signal from one place to another. If your console has auxiliary sends or bus outputs, the outputs would also be dedicated to a row on the patch bay.
What is a Normalled patchbay configuration?
A Normalled patchbay has vertical pairs of jacks (usually In and Out) where audio automatically flows between the two jacks. Usually, patchbays rear panel connections have some option for normalling. Normalled patchbays can be Full-Normalled, or Half-Normalled.
What does Normalled mean in audio?
Normalling refers to a specific wiring pattern (within a patchbay) that creates a path from one piece of equipment to another without the use of a patchcord. With the patch bay left as it is (no patch cord inserted) the signal will flow from some output (top jack) to some input (bottom jack) in its normal fashion.
Which is the best patchbay on the market?
The ART P48 is a TRS-equipped 48-point balanced patchbay that’s been said to have reliable performance in a rugged steel chassis. Switchable between normal and half-normal modes, it does away with the “thru” setting found on most other units.
What does it mean to have a patch bay?
A patchbay is all about convenience… … particularly to the studio owner with a growing gear collection, or who needs an easy way to manage lots of connections. Sometimes spelled “ patch bay” or “patch panel,” (Wiki links) it’s an electronic device that allows you to rout incoming audio signals to any one of several physical outputs.
How many front pairs does Neutrik NYS-spp-l1 have?
Neutrik’s NYS-SPP-L is a professional 48-point 1/4″ TRS patchbay with 24 front pairs and 24 rear pairs. That makes it easy for you to get your patching jobs done right.
What kind of connector does a patch bay need?
Patch bays are typically fitted with TRS jacks, which will accommodate most types of audio equipment. Depending on your needs however, you may opt for patch bays that have XLR, RCA, mono TS, or some other type of connector.