Will a 302 intake fit a 351?

Will a 302 intake fit a 351?

Intake won’t cross over, The 351 has a taller deck than the 302. The timing cover will bolt on but ford used three different timing marks so it may not be right for the damper, which also must match the flex plate balance and the engine should have been balanced to match both.

Will a 5.0 intake fit a 351 Windsor?

You have to get the correct pieces from a dealer/junkyard. 3) The deck height is higher, which means you need a different intake, since the 351W intake is wider. A 5.0 Upper will bolt to a 351W lower.

Will a 289 intake fit a 351W?

the intake from the 289 can fit a 351w, using some fancy CNC machine adapters I have seen. Some old school guys have done this to use the 6-pack set-ups from 289’s of the day.

Will a 302 intake fit a 289?

Edelbrock part #2121 Performer 289 intake manifold is designed for street 260-289-302 c.i.d. Ford V8’s without EGR. Will not fit Boss 302 or 255 c.i.d. V8’s.

Are 302 and 351W blocks the same?

You can spot the difference pretty easily by looking at the front of the engine. On a 302 (or smaller c.i.d.) blocks, the distributor mount is almost flush with the top of the block (where the intake sits). A 351W block is taller. So, the distributor mount is below the block surface where the intake sits.

Are 302 and 351 flywheels the same?

Your 302 bellhousing & flywheel will bolt up and work fine behind a 351w.

Are 302 and 351W motor mounts the same?

Same mounts but the deck is a bit taller, making it a bit wider. As long as you have the room, you’re all set. The motor mounts will be no problem.

Are all 351 Windsor blocks the same?

It shares the same small block V8 bellhousing pattern and motor mounts of the August 1964+ Windsor engines*. All post-August 1964 Windsor engines use a wider 6-bolt pattern (including all 351W), commonly referred to as the small block V8 pattern. The patterns are not interchangeable.

Are 289 and 302 blocks the same?

Basically the same block. The 289 has a 4″ bore with a 2.87″ stroke while the 302 has a 4″ bore with a 3″ stroke. Yes the 302 parts will fit just fine in the 289. Be sure to use 302 rods as they are shorter then the 289’s.

Are all 302 intakes the same?

Yep, 289/302 intakes are all interchangeable.

Are all 351W blocks the same?

There are 4 main types of 351w blocks. I have seen quite a few 70-74 blocks take 800-1000 flywheel HP when converted to 4-bolt main.