What does Nissan consult do?
It is the diagnostic tool that Nissan/Infiniti technicians use to communicate with the ECU. In most cases it is capable of advancing timing, but it’s mostly for diagnostic monitoring.
What obd2 protocol does Nissan use?
| Protocol | Mode 1 | Mode 6 |
|---|---|---|
| ISO 9141 | BE1FB811 80000000 | Non |
What is a Nistune ECU?
Nistune is a real-time tuning suite designed especially for Nissans which provides the ability to: • Retune factory Nissan Engine Control Units (ECU) • Monitor gauges and map tracing on your ECU. • Data log from your ECU using consult, wideband and auxiliary inputs. • Perform playback using graphs, gauges and map …
When did Nissan start using OBD2?
OBD2 was introduced on all 1996 and newer model year passenger cars and light trucks sold in the United States.
Is Nistune good?
Nistune is a great option for standard, mild and moderately modified road vehicles. It is designed to use factory Nisan sensors, so these must be in good usable condition. PBMS recommend upgrading to modern aftermarket engine management for high power (300kw+) or motorsport use.
Can Nistune run MAP sensor?
10. Can you use a MAP sensor with Nistune? Nissan ECUs do not support MAP sensors. Standard OEM MAF sensors have room for about 10-20% extra power before they top out.
What OBD protocol does Nissan use?
What kind of data scan software does Nissan use?
The Nissan DataScan II software supports factory Nissan and Infiniti ECUs. The Nissan DataScan III is intended for newer Nissan and Infiniti cars equipped with a grey 16-pin OBDII connecter and using CAN network for diagnostics. A list of cars that the software has been tested on is located on the NDSIII Supported Vehicles page.
Can you use Nissan datascan on Nissan consult II?
Nissan DataScan II software works on a range of Nissan Consult II cars. You must have an OBDII connector like the one below to be able to use this software. Not all Consult II cars are supported by this software. Nissan DataScan II software has been tested on following cars:
What kind of adaptor do I need for Nissan datascan?
The software can be used with the BlaztII design adaptor and a generic “dumb” VAG COM OBDII adaptor. The ELM adaptors are not compatible. The Nissan DataScan II software supports factory Nissan ECUs. Aftermarket ECUs like Apexi Power FC or F-Con V Pro are not compatible with the software.
How can I get a knock sensor reading on my Nissan datascan II?
A knock sensor reading can be obtain using this method if knock sensor memory address is known. Nissan DataScan II also supports wideband Air/Fuel ratio meters from Innovate Motorsports. A second serial port is used to connect to the controller and collect data.