Can subframe be welded?

Can subframe be welded?

Yes , no problem at all with welded repairs to the subframe. Try to use the same thickness metal as original, this may vary on different parts of the subframe, the thinner parts being aprox 20 gauge and 18 gauge for thicker parts. These are probably best seam welded for strength.

How much does e46 subframe reinforcement cost?

If you’re in the Northeast/TriState area, you’re looking at $1,700 + (parts included). The job is labor intensive and your quote may be higher if your car has already developed cracks. If you plan to keep the car I would suggest topside (Vincebar) and underside reinforcement (Reddish/PS Design plates) of the rear.

How much does it cost to reinforce the subframe in an e46?

The average cost of the reinforcement is $1500.00 The cost of the repair after a failure would be determined on a case by case basis. Call, text or email today to set up an appointment and get on our schedule!

Can a broken subframe be welded?

Eventually, if you need to drop the subframe, you will have to cut, but it can all be welded again after another aligning.

Can you cut and weld a subframe?

you can weld it, cut out the old and make a new peice out of 1.2mm metal.

Is the BMW E46 rear subframe reinforcement kit Universal?

The E46 Rear Subframe Reinforcement kit has been designed to provide the best repair and reinforcement option available on the market, regardless of crack damage, age, mileage, service history or modifications made. The kit is universal to the entire E46 BMW 3 Series model range regardless of body type, transmission or engine size / type.

Is there a fix for a BMW E46?

BMW even has an official fix for non-damaged cars. However, every E46 on the road potentially needs rear floor repair and reinforcement and it’s a absolute must-do for any track or race car project.

What to put on BMW rear subframe to prevent it from flexing?

Urethane or solid aluminum mounts are strongly recommended, even on street cars, as they do not allow the subframe to flex. BMW’s official fix was to inject structural foam between the two layers. When the foam is fully hardened it adds strength between the sheetmetal layers and prevents them from flexing.

Can you use epoxy on a BMW E46?

Partial reinforcement (skipping the trunk portion) is not advised and undermines the effectiveness of our kit. Installing the plates using epoxy or adhesive is also not recommended and pointless since you must weld the top subframe mounts anyway. The rear floor of the E46 is actually two sheets of steel with a gap between them.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top