Do I need vertical closure strips for polycarbonate roofing?
Closure Strips Plastic vertical closures are recommended for finishing the outside edges. Foam closures can be stretched slightly to align with the panels to form a compression fit.
How do you seal the ends of a corrugated roof?
Insert a tube of butyl caulking into a caulk gun and snip the end off using sharp scissors. Apply a 1/4-inch wide bead of caulk over the seam where the two panels overlap. Work your way across the entire roof to apply caulk to all remaining seams to seal them.
Do you have to use closure strips for metal roofing?
Are Foam Closure Strips Necessary For Metal Roofing? Yes, metal roofs will require both inside and outside foam closure strips at various metal roofing flashing details. It’s an important step of the installation process that protects against wind driven rain.
How much do you overlap polycarbonate roofing?
When joining the sheets, overlap one and half corrugations for the corrugated profile. And one overlap for the Greca profile. Make sure that your overlap sequence is away from the prevailing wind.
Where do you put butyl tape on a metal roof?
Butyl/Sealant Tape designed for side and end lap sealing of metal panels, roof vents and pipe flashing, Butyl/Sealant tape provides optimum sealing in harsh environments and adheres to most clean dry metal surfaces and does not harden, bleed or stain.
Is a drip edge necessary on a metal roof?
A drip edge is not needed for metal roofing. If you make sure to overhang your metal roofing at least an inch, the drip edge is not necessary at the eaves and rakes. If the metal roof is hanging over an inch, the water will be directed away from the fascia anyway if at a slant.
What is the difference between inside and outside closure strips?
Inside closure strips are used under the roofing (i.e. eaves). Outside closure strips are used on top of the roofing(i.e. ridge).
What kind of closure strips do suntuf use?
Closure Strips Suntuf’s closure strips are made from wood, plastic, or foam. Foam closures are recommended because they can be stretched slightly to align with the panels to form a compression fit.
Are there universal closure strips for palruf roofing panels?
The Suntuf 24 in. Universal Vertical Plastic Closure Strips (6-Pack) are versatile enough to Fit Palruf, Suntop, and Suntuf roofing panels (not included). They provide support and a finished look to your roofline. You will need Adobe® Acrobat® Reader to view PDF documents.
What’s the best way to cut a suntuf panel?
Suntuf panels can be cut or sawed by manual or power tools. A bench / table circular saw is best for straight long cuts. For better results cut a few panels together. Portable circular saws are suitable for on-site straight cuts. Fine toothed blades recommended for cutting plastics (particularly polycarbonate) should be used.
What’s the temperature at which suntuf panels melt?
Suntuf panels will melt down at approximately 400ºF, generating openings for smoke release in the event of fire. Sawing, Cutting and Drilling 1. Suntuf panels can be cut or sawed by manual or power tools.