How much is a water pump for a 2002 Chevy?
2002 Chevrolet Impala Water Pump – from $11.99+ | AutoZone.com.
How much is a water pump for a 2002 Chevy S10?
Chevrolet S10 Water Pump Replacement Cost Estimate. Labor costs are estimated between $125 and $158 while parts are priced at $196.
How do you change a water pump on a Chevy S10?
Loosen the bolts and remove the old water pump. Remove the old seal/gasket or old sealant remains and make sure the mounting surface is clean. Before installing the new water pump, inspect the other cooling system service parts: coolant hoses, thermostat and pressure cap(s). Install the new water pump.
How many hours does it take to replace a water pump?
Expect to pay $200-$450 total for labor, depending on the how difficult it is to reach the water pump, any additional parts that need to be removed and whether the car uses a timing belt or timing chain. The job takes about three and a half to four hours to complete.
How much dies it cost to replace a water pump?
The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314.
How much does it cost to replace a water pump in a 2000 Blazer?
The average cost for a Water Pump Replacement is between $419 and $473 but can vary from car to car.
Will a 4.3 water pump work on a 350?
Registered. Yes, a water pump for a small block chevy will work. A 4.3 is basically a 350 with two cylinders cut off. The water pumps should have no problems interchanging.
Can I change my water pump myself?
While removing the pump is not difficult, you must have experience removing and replacing timing belts and their various components. It takes just as much work to get down to the timing belt as it does the water pump, therefore you should plan on replacing the belt at the same time.
What causes a water pump to go bad?
The most common water-pump failure is due to worn bearings. Water pumps move a tremendous amount of coolant, and they just simply wear out over time. And mixing coolants, or using the wrong coolant, can cause damage to the water-pump seals and bearings, and can lead to the impeller shaft to fail.
What is the signs of a bad water pump?
Five Signs Your Water Pump Is Failing
- Overheating. A dead or dying water pump cannot circulate coolant through your vehicle’s engine and, as such, the engine will overheat.
- Coolant Leaks. Coolant leaks from the water pump are common and a clear sign that it’s time to replace the pump.
- Corroded Water Pump.
- Whining Noises.