Can you shoot a bow with a shorter draw length?

Can you shoot a bow with a shorter draw length?

An archer can shoot good groups using too short of a draw length but will perform with tighter, more consistent groups with the correct one. Successful results are very difficult and unlikely when the draw length is too long. Some bows are very user-friendly in terms of altering the draw length.

What is the proper draw length for a compound bow?

DRAW LENGTH First, spread your arms outward from your side to form a “T” with your palms facing forward. Next, have a friend measure your wingspan from the tips of your middle fingers. Divide this number by 2.5 and you should be relatively close to your actual draw length.

How do I know if my bow is too short?

If you pull the string back as far as it’ll go and you can’t reach your head, then it’s way too short. If you pull the string back and it goes behind your jaw, it’s way to long. You usually want the string to be around the corner of your mouth area.

What happens if bow draw length is too long?

Many bowhunters shoot a draw length that is too long for them, which hurts shooting form and degrades accuracy. You hear this all the time–that a long draw overextends your bow arm and makes it harder to hold against the back wall and to maintain a consistent anchor point.

How long should arrows be for a 26 inch draw?

How long should my arrow be for a 26″ draw? If you are using a bow with a 26″ draw, the correct arrow length would be 25″.

Where should my draw length be?

To measure your draw length, stand with your back to a wall stretching your arms out against the wall. Measure the distance from the end of your middle finger to the end of your other middle finger, basically the length of both arms, hands and chest. This measurement, minus 15 then divided by 2, is your draw length.

How long should arrows be for a 27 inch draw?

The arrow must be 29″ in length and supported by two points, which are 28″ apart. The number of inches the arrow deflects or bends due to the weight, is the spine size or measurement of an arrow. DYNAMIC spine describes the way an arrow reacts from the stored energy of a bow as it is shot.

How long should arrows be for a 30 inch draw?

The Easton spine chart recommends a spine of 250 for a 30-inch arrow shot from a bow set at 70 pounds. Cut that arrow length down to 28 inches, and the spine chart recommends a 340 spine.

What draw weight do most hunters use?

Some shooters are capable of shooting 70, 80 or 90lbs, but most adult males shoot between 60 and 70lbs. Today’s bows are extremely efficient and 40lb compound bows are more than capable of harvesting many big game animals. For whitetail deer hunting anything above 40 lbs is fine.

How do I know my draw weight?

To measure your draw weight, you must find the point where the draw is at its heaviest. For recurve and traditional bows this is at the end of the draw. For compound bows, this is approximately in the middle of the draw. You can use a bow scale, spring balance, or luggage scale to get the actual measurement.

How do you determine the length of a compound bow?

If you draw a compound bow back to full draw, the official draw length is found by measuring the distance from the nocking point on the string, in a line perpendicular to the center line of the bow, to an imaginary point above the pivot point of the grip, plus 1.75 inches.

How do you draw a compound bow?

To draw a compound bow, your hands should start about at nose height, with your grip hand and the release hand extended in front of you and in line with your target. Photo Credit: World Archery Keeping your grip hand steadily extended at nose height, you then use your release hand to start pulling the bowstring toward your face.

How do you measure bow’s draw length?

To get your draw length, divide your wingspan by 2.5. Wingspan / 2.5 = Draw Length. This calculation is not exact, your draw length my vary slightly from the number you get, but it will get you a figure that can help you approximate appropriate bow length, safe arrow length, and compound bow draw length.

How to determine your draw length?

To get your draw length , divide your wingspan by 2.5. Wingspan / 2.5 = Draw Length . This calculation is not exact, your draw length my vary slightly from the number you get, but it will get you a figure that can help you approximate appropriate bow length , safe arrow length , and compound bow draw length .