How much HP can a Dana 30 take?

How much HP can a Dana 30 take?

Amongst other things. To answer your question the stock supports 250 or 300 if you don’t savage it. Run that rear until it blows, then stick an 8.8 in there.

Will Dana 35 gears fit in a Dana 30?

a Dana 30 is a front axle. A Dana 35 is a rear axle (unless you are talking about Ford axles, which you aren’t). The parts are not interchangeable. Edit: unless you mean interchangeable between the Dana 35’s, then yes they are.

How big of a tire can a Dana 35 handle?

They can and will break at any time, don’t push your luck with tires bigger than 31″. The front can handle 35’s just fine but over that and it needs attention.

Can you make a Dana 35 strong?

There are two options when upgrading the 35 shafts. Superior Axle & Gear offers its Super 35 kit and Warn has a full-float kit. The Super 35 kit is available for both C-clip and non-C-clip axles. The kit replaces the smallish shafts with 1.31-inch 30-spline pieces that are over 35 percent stronger than stock.

Can you run 37s on a Dana 30?

It has all the same weak parts as a 30, just a larger ring gear. With 37s, you can also break a D44 ring gear.

Can a Dana 30 handle a V8?

The stock Dana 30 (same shaft size as a Dana 44) should hold up just fine up to a 35” tire. If you upgrade your Dana 35 to a super 35 (beefier 30-spline axles shafts), it would handle the V8 power just fine too. Common misconception about the Dana 35 is that the c-clips are the weak point, which isn’t true.

Is Dana 30 a good axle?

The 30 has been proven as a good little axle as long as the tires stay under 36″ or so. Like I said, I run 35’s, 4.88’s, full locker and the stroker and I beat the piss out of it and have had almost no problems with it.

Will 4.56 gears fit in a Dana 30?

4.56 gears will work in a LP Dana 30 if that is the question regardless of your current gears. The carrier break in a Dana 30 is 3.54-3.73 so if you have below 3.73 you’ll need a new carrier but that’s no big deal.

Will 4.56 gears fit in a Dana 35?

Registered. I run 4.56’s in my Dana 35 for my 33’s. If you have respect for your 35, and use it within it’s limits without pushing the envelope, you should be fine keeping your 35.

Can Dana 35 Handle 35 tires?

Yes, a built Dana 35 with a Super35 kit installed can handle 35s.