How do you service the StabiliTrak?

StabiliTrak can sometimes be repaired by cycling the basic engine ignition:

Stop and turn off your vehicle.
Let it sit for at least 20 seconds.
When you start the standby vehicle, the notification should go away.
If it does not, you should get assistance.

Why does my Impala says service StabiliTrak?

The “Service StabiliTrak Warning” indicates the system is not responding or operating as it should. A failed brake switch will also disable the system as well as the wrong size of tire. The cost of replacing the Impala’s wheel sensor averages $100-$120 in parts and labor.

Where is traction control sensor?

In some vehicles it is located under the hood and/or is a part of the ABS control module. Other vehicles may have the traction control module located in the interior or trunk areas.

How do you turn the StabiliTrak off in a Chevy Impala?

How to Disable the Traction Control Sequence on an Impala

Sit in the Impala’s driver side seat. Crank the engine. Inspect the left side of the dash.
Locate the button to disable the traction control. It is between the headlight control switch and the steering wheel.

What does it mean if my car says service StabiliTrak?

This is actually a common message that usually means there is nothing to worry about. It just means that StabiliTrak is not currently able to initialize. This can be due to a variety of reasons including road conditions or improper tire size. If the message persists, then you should take your vehicle in for service.

Can I drive my car with the StabiliTrak light on?

Is it Safe to Drive with the TCS Light On? It is only safe to drive with the TCS light on if it appears when you are losing traction: it means the system is engaging. Driving without traction control can make your vehicle susceptible to spinning out and sliding around on the road.

How do I reset my traction control light?

The first thing to do, if your traction control warning light comes on while you are driving, is to find a safe spot to pull over. Turn your vehicle off, then restart it. If the traction control warning light stays off, there was a momentary glitch in the system, and you should be fine to continue.

What are the signs of a bad traction control module?

Symptoms of a Bad or Failing Traction Control Module

Traction Control System Warning Indicator Light is on.
Traction Control System (TCS) won’t turn off/on.
Loss of Traction Control System (TCS) features.
Loss of Anti-Lock Brake System (ABS) features.