How do I reset my Whirlpool quiet partner 3 dishwasher?

How do I reset my Whirlpool quiet partner 3 dishwasher?

How to Reset a Code for a Whirlpool Quiet Partner 3

1. Press the “Sani Rinse,” “Heated Dry,” “Sani Rinse” and “Heated Dry” buttons on the dishwasher’s electronic control panel in quick succession to put the appliance in diagnostic mode.
2. Close the dishwasher door and engage the door latch.

How do you reset the control board on a Whirlpool dishwasher?

Resetting the control board To reset the control board, push the “off” key and remove its power cable. After ten to fifteen minutes, plug in the cord, then turn on the dishwasher and click on “high setting” or “pots and pans” on the control board. Finally, press any “heat” round to dry the dishes on the wash.

Do Whirlpool dishwashers have a reset button?

The downside to Whirlpool appliances is that they don’t have a reset button. But some of them do have certain error codes. If you can’t identify the error code, let’s start with the most basic step. Simply disconnect your dishwasher from the power source and leave it for one minute.

Does Whirlpool dishwasher have reset button?

How do I reset my Whirlpool Quiet Partner IV?

So, now to reset the control so you can test it. Press the following buttons within 5 seconds… This will reset your control and allow a cycle to be started. Make sure the door is tightly closed and run a cycle and see if the clean light blinks again at cycle end.

How do you run a test cycle on a Whirlpool dishwasher?

Press and hold the start button and turn it back on. Hold the start button in till the start light is flashing then let go. Now press the start button once and close the door. Now it will run a 12 minute test cycle.

Why is my Whirlpool dishwasher locked?

Is the control lock “on” or is the dishwasher in sleep mode? The control lock is used to avoid unintended use of the dishwasher as well as to avoid unintended cycle or option changes during a cycle, some model have a sleep mode function.