How tight should weight distribution bars be?
The answer to the question- *if* the hitch is properly set up to begin with, the bars should be tight enough that the front and rear of the tow vehicle drop the same amount, because the purpose of the hitch is to take the weight of the hitch and divide it equally between the front TV axle, the rear TV axle, and the …
Can you put too much tension on weight distribution hitch?
Expert Reply: If you have the spring bar tension set up too high you can see ride issues. Typically it’s a very harsh ride quality but sway is possible too. The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow.
Should I grease my weight distribution bars?
According to Reese you need to lubricate the ball mount sockets, hitch ball, and spring bar trunnions. The trunnions should be lubricated daily and when in use. You need to lubricate the upper and lower trunnion pivot pins and contact area in the ball mount sockets.
How does a Reese weight distribution hitch work?
A Reese Weight Distribution System evenly distributes the weight of the trailer between the trailer axles and the tow vehicle axles. The result is a more level ride, which reduces stress on the rear of the tow vehicle while providing greater steering and breaking control. A weight distribution kit is installed.
Can you back up with weight distribution bars?
If using a weight distribution system that does not come with sway control at all then backing up would not be an issue unless making severe turns (jackknifing the trailer) and you would want to remove the spring bars ahead of time.
Why does my weight distribution hitch make so much noise?
Noise is a normal occurrence when towing a trailer and using any weight distribution or sway control hitch. In some cases the friction on the L-brackets can generate noise. Lubricating this joint is not recommended. A better solution is a set of official Equal-i-zer brand Sway Bracket Jackets™.
Do you need a sway control for a weight distribution hitch?
Weight distribution and sway control in one product! The TruTrack™ weight distribution hitch features an innovative design that levels the vehicle-trailer combination, while actively keeping the trailer from swaying. No need for a separate sway control unit!
How do you mount a weight distribution hitch?
Rotate the head up into the mounting position on the shank. It should be vertical or tilted slightly back. You may need to add or remove washers to achieve the proper angle. Finally, insert the second bolt into the top hole in the hitch head and fasten both bolts with the provided nuts and washers.
What are the different types of Curt hitches?
CURT weight distribution hitches come in two styles: round bar and trunnion bar. These refer to the types of spring bars used by each style. A round bar weight distribution hitch uses round spring bars attached to the underside of the WD hitch head, and a trunnion bar weight distribution hitch uses square bars mounted at the face of the hitch head.
How many chain links do you need for a trailer hitch?
Note: There must be a minimum of five chain links between the bracket and the spring bar. Retract the trailer jack so that the full weight of the trailer is resting on the hitch.