How do you remove the front turn signal on a Harley Davidson?
Loosen the Allen head bolt located under the left or right handlebar switch pod, using a 1/4-inch Allen wrench. Pull the front turn signal ball post out from the bottom of the switch pod, then pull the turn signal wiring out from the motorcycle’s frame until the turn signal has been removed completely.
How do you remove a rear turn signal cover?
Locate the turn-signal cover and the screws that are holding it in place. Use either a Phillips, slotted or, in some cases, a specialized screwdriver — sometimes called a star — to remove the screws holding the lens cover in place. Gently pull out on the lens cover.
What should I know before removing turn signal wiring?
When removing turn signal wiring, refer to appendix in applicable Service Manual covering detailed procedures for Amp Multilock Electrical Connectors. Prior to removing turn signal wires, carefully note routing. In particular pay close attention to the locations of cable straps which must be replaced.
Where to terminate ground wire on Harley Davidson?
When performing the next step on 1994 and earlier models, terminate the ground wire (Black) using ring terminal P/N 9858 and secure to ground screw or other suitable location. For power wire, use terminal as described in previous note and route following same path as original.
How do you attach a lamp to a Harley Davidson?
Screw ball stud assembly into right side lamp housing. Tighten jamnut against lamp housing. Attach lamp housing to handlebar housing by screwing ball stud clamp onto receptacle.
What should I do if my Harley Davidson is not installed?
Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)