What does a Power Commander do for a GSXR 600?
The Power Commander V is a unique EFI tuning device because it can monitor and maintain your air/fuel ratio without directly changing the ECU. To reinstate your stock settings, all you need to do is uninstall the device, and you’re done.
How much HP does a Power Commander add?
The Power Commander is a tuning tool to adjust fuel, and on some models ignition timing. Just adding a Power Commander to a completely stock vehicle usually does not increase peak horsepower. It usually will improve drivability, throttle response, and mid-range horsepower and torque.
Where is the Power Commander located?
Software Installation Plug your Power Commander V into your computer using the supplied USB cable. The port on the Power Commander V is located on the right side of the device and is weather protected by a rubber strip that you can peel back. Click View > Show Notes to see a description of the map on your device.
How does Power Commander AutoTune work?
Once installed, the AutoTune kit monitors the air/fuel ratio. It then sends this information to the Power Commander V and automatically corrects it as you ride, letting you feel the changes as they happen.
Do I need a power commander with a full exhaust?
Registered. You don’t NEED a power commander, the bike will still happily run the same as it always did, but if you want a smoother operating throttle and the highest HP gains from the pipe, go with the power commander.
How much does it cost to install power commander?
Cost here is about $300 depending on where I get it. Shop: My local shop says they will install and set the bike up on their dyno for $550+tax. They also said the fuel map will be set at 500 RPM increments form idle to 11500 rev limiter and guaranteed perf increase over stock.
How do you set up a Power Commander?
Hold down all three buttons on the face of the Power Commander unit and turn on the bike’s ignition. Release all the buttons once the engine is idling normally. The Power Commander manual recommends waiting approximately 20 seconds before making any adjustments.
Can a power commander be installed under the seat?
Featuring a plug-and-play kit, Power Commander V can be installed discreetly underneath your seat, ensuring your ride looks as good as it runs. The Power Commander V is a unique fuel tuning device because it can monitor and maintain your air/fuel ratio without directly changing the ECU.
What can I do with a power Commander V?
From Ignition Modules for adjusting timing to Quickshifters and more, our Power Commander V is the first step for a full bike overhaul. Our C3 Tuning Software can store all of your data from your fuel tuner onto your computer and compare it side by side for even more insight into your performance.
What does the power Commander V fuel tuner do?
Take control of your ride with the Power Commander V fuel tuner — built to give your bike more horsepower to the ground (wheel horsepower), optimized driveability and the fuel efficiency you need to leave routine in your dust.
What kind of connector does power Commander III use?
It uses OEM (original equipment manufacturer) style connectors making installation easy and quick. The Power Commander III USB allows a full range of fuel adjustment, as much as +/- 100% over stock. Adjustments can be made either with a Windows based computer or by using the face plate mounted button adjusters.