How do you reset a Franke hot tap?
a) Hold the ON/OFF button for 5 seconds. The message will reset and switches the boiler OFF. b) Now switch ON the boiler again. If the boiler gives the same error message again after a reset, turn it off and contact your installer or Franke Customer Services.
Why is my Franke tap flashing red?
Red – Indicates that the water filter cartridge needs replacing. Yellow – Indicates that the two AAA batteries in the module need replacing. Important note: Do not plug the boiler into the power supply at this stage.
How do you descale a hot water tap?
Begin the cleaning process by mixing one cup vinegar with one cup of water. Stir the solution to make sure it’s properly mixed. Then, add it to the water tank and close the lid. Leave the solution to stand for anywhere between 30 minutes up to 1 hour.
What is the tank capacity of a Franke instant boiling water tap?
4 Ltr
Answers
| Specification | |
|---|---|
| Spout Reach | 220 mm |
| Spout Type | Swivel Spout |
| Supplier Manufacturer Helpline | 01603 875 468 |
| Tank Capacity | 4 Ltr |
How do I change a Franke cartridge?
Remove the new filter cartridge from its packaging, wet the “O” seal and place it in the filter sump. Position the sump, with the cartridge inside, under the filter head and screw it in place. The cartridge should engage automat- ically. Tighten the sump, sufficient to make a water tight seal.
How long does a quooker scale control cartridge last?
The filters will, over time, become less efficient and must be replaced regularly (approx every 12 months depending on the hardness of the water/usage) to ensure this reliable descaling process continues to work effectively.
How do I change my quooker water filter?
Disconnect the head by unscrewing the grooved knob on top of the Scale Control. Remove the Scale Control from the kitchen cup- board. Unscrew the lid and replace the old cartridge with a new one. Screw the lid onto the container until it clicks into place.
How do you remove calcium deposits from a hot water dispenser?
Descaling using vinegar or citric acid
- You can use ordinary vinegar (white or malt) or citric acid to descale your HotCup water dispenser.
- If you are using vinegar, make up a solution of 1 cup vinegar to 1 cup of water.
- Pour the solution into the tank, close the lid and allow it to stand for 1 hour.
Do boiling water taps get limescale?
Without a doubt a build-up of limescale can adversely affect many of our kitchen appliances. Dishwashers, washing machines and boiling water taps are perhaps the most obvious, but limescale is also a problem for steam ovens, irons, steam cleaners, sinks and taps; and even sanitary ware and shower screens.
What is a 3 in 1 tap?
It delivers the convenience of standard hot, cold and boiling water, all from one spout. Styled with an elegant swan spout and dual lever operation this beautiful tap will look fabulous in any kitchen.