How much does it cost to have a stator replaced?
Stator & Rotor A new stator and rotor set typically costs between $250 and $1,500. They are stationary and rotating parts of any system that generates electricity. When they stop working seamlessly, they need repair or replacement.
How do I know if my stator is bad on my Harley?
What are the symptoms of a bad motorcycle stator? The most obvious symptoms of a bad motorcycle stator include no spark, weak spark, or intermittent spark (also known as misfiring). Hard starts and a poorly running engine can also be clues that your stator needs to be rebuilt or replaced.
How long does it take to replace a Harley stator?
How long does it take to replace a stator? You should be able to get in and out under 3 hours.
How long does it take to change a stator on a motorcycle?
You should be able to get in and out under 3 hours.
How much does a stator cost for a motorcycle?
Compare with similar items
This item Accel 152115 50 Amp 3-Phase Motorcycle Stator for Harley-Davidson | Cycle Electric Stator CE-8012 | |
---|---|---|
Customer Rating | 4.4 out of 5 stars (21) | 4.1 out of 5 stars (22) |
Price | $25368 | $17695 |
Sold By | Midwest Traction | Longhorn Moto |
Item Weight | 3.15 lbs | 4.00 lbs |
What problems can a bad stator cause?
Runs bad at lower rpms but runs good at higher rpms (Low speed coil going bad) Runs good at lower rpms but runs bad at higher rpms (High speed coil is going bad) Backfiring and just won’t run good. Sled slowly loses power during the course of the day.
What would cause a stator to go bad?
To answer why stators fail, it is because the coating on the windings breaks down, usually because of heat, causing a short which can also burn the fine wire of the winding in two at the short causing an open circuit. The way to prevent failures is to prevent the heat.
Do you have to drain oil to change stator?
No, you shouldn’t need to even on a side stand. You might get a little oil out, but not a lot.
How hard is it to replace a stator?
Replacing the stator is not too complicated and requires a socket set and some heat resistant gasket repair silicone only. On 2006-07 Honda Fireblades the stator is located on the left hand side behind the crash protector.
When to use 100% stator earth fault protection?
The 100 % stator earth-fault protection can also be used for generators with unearthed neutral. The third harmonic voltage between the neutral point and earth will increase compared to generators with earthing resistor and the third harmonic undervoltage (100 %) function can cover a larger part of the stator winding.
Is it possible to rebuild an old stator?
Most new and rebuilt stators are built to stock specification, but we do offer some high output stator versions as part of the Hot Shot Series so you can get even more electrical power from your machine. Call us at 603-329-9901 to inquire about a custom rebuild on your old stator.
How to protect 95% of stator windings?
In case of an earth-fault on the stator winding and no additional fault resistance, the fundamental frequency neutral point voltage is increasing in proportion to the distance of the fault from the neutral point. Hence a voltage relay set to 5 % of the stator phase voltage will protect 95 % of the stator winding.
How is the stator of a generator protected?
Normally, the Generator produces about 1 % or more third harmonic voltage under all service conditions, can have the entire stator winding, including the neutral point, protected using a scheme which combines the neutral point voltage function (95 % relay) and a third harmonic under voltage function.