Can you put a magazine in a revolver?

Can you put a magazine in a revolver?

Mag/Magazine: Nope. Revolvers don’t use magazines. The speedloader itself isn’t inserted into the revolver. A speedloader is a device for quickly dropping ammunition into a revolver’s chambers.

Do they make a 44 40 pistol?

Cimarron Model P Revolver . 44-40 Win 5.5″ Barrel 6… Cimarron Model P Revolver 44-40 WCF 7.5″ Barrel 6 Rounds Case Hardened Pre War F…

Does a revolver have a clip or a magazine?

While revolver cylinders are not considered magazines, they can use clips in a slightly different way than rifles do. A half moon clip is usually seen chambered in automatic pistol cartridges such as 9mm or . 45 Auto.

Does leaving a magazine loaded damage the spring?

Even when kept fully compressed, a magazine spring will retain its energy long past the operational life of the ammunition.

Who makes the most accurate 22 revolver?

1. Smith & Wesson 317 Kit Gun: So named because it’s small enough to fit in a hunter, hiker or angler’s kit box, the 317 is a compact, lightweight . 22 LR revolver that’s tough as nails and surprisingly accurate.

Can revolvers hold 12 rounds?

However, some revolvers have 7, 8, 9, or 10 chambers, often depending on the caliber, and at least one revolver has 12 chambers (the US Fire Arms Model 12/22). Partially because of these reasons, revolvers still hold significant market share as concealed carry and home-defense weapons.

How is the accuracy of a revolver determined?

Revolver accuracy is dependent on several points starting with the diameter of the cylinder throats which should be .001″ TO .002″ larger than the bullet diameter. For instance a 38 special or .357 magnum cylinder throat should be .358″ .359″, but no larger.

What kind of action work can I do on a double action revolver?

Complete action job on double and single action revolvers which includes honing and lightening the action, cutting a 60 degree crown, polishing, numbering and beveling the chambers, cutting the forcing cone to 11 degrees and other work…………………. $245.00.

What should the grooves be on a 38 caliber revolver?

The barrel throat should meet SAAMI specs and idealy should be cut to 11 degrees. Barrel grooves should be the same diameter as the bullet such as .357″ for a 38 caliber. The crown should be cut square to the bore and it does not seem to make any difference if it is 90, 45 or 60 degrees just as long as it is square to the bore.

How much does it cost to change the barrel on a revolver?

Changing barrels such as on a single action, S&W, or others starts at $145.00+ and runs up quickly depending on the revolver. Price is for labor only. Set barrel back to close gap and recut forcing cone to correct specifications….. $185.00 for one turn, $295.00 for two turns and $395.00 for three turns.