How do I reset my White Rodgers air conditioner?

How do I reset my White Rodgers air conditioner?

The most common method of resetting the White-Rodgers Thermostat is by pressing down on the Up or Down arrow and the Time button at the same time until the display goes blank on your White-Rodgers Thermostat. This usually takes 15 seconds.

How do I reset my thermostat to factory settings?

Here are the step-by-step reset instructions:

  1. Turn your thermostat off by switching it to the off position.
  2. Find the breaker that powers your HVAC system and turn it off.
  3. Wait 30 seconds and turn the breaker back on.
  4. Turn your thermostat back on.

How do I reset my White Rodgers Emerson thermostat?

Press and hold the up or down arrow and the time button at the same time. Hold the buttons down for 10 seconds. The display will go blank and reappear after a few seconds. The thermostat is now reset.

How do you reset a White Rodgers thermostat after changing the battery?

Generally, you’ll need to open the thermostat cover and detach the wires from terminals R and C. Next, remove the batteries for a couple minutes and then replace them. Program your thermostat to the ambient temperature. If you hear one click, your thermostat has been reset.

How do I get my White Rodgers thermostat out of lockout mode?

Force the thermostat to unlock if you do not know the keypad lockout code by touching the “Menu” button and holding your finger there for approximately 20 seconds. When you first touch the “Menu” button it will disappear. Keep your finger in the same location until the thermostat unlocks.

How do you reprogram a White Rodgers thermostat?

To program your White-Rodgers thermostat, press the PRGM button on the thermostat for a basic thermostat. For the touchscreen White-Rodgers models, press the SYSTEM button to the mode you want to program and use the buttons to adjust the parameters.

How do you reset a White Rodgers thermostat 1f78 non prgm?

Hard Reset

  1. Remove the cover plate.
  2. Remove the wires from terminals R and C (or RH and RC), taking care not to short them together.
  3. Remove the batteries for 2 minutes.
  4. This procedure will reset the thermostat.
  5. Replace the wires, batteries, and cover plate.
  6. The display should now show in its factory reset state.

How do I reset my digital thermostat?

A common way to reset almost any thermostat is to hold down the reset button for 5+ seconds. Alternatively, try resetting battery-powered thermostats by flipping the battery directions around for 5s, then flip them back. If all else fails, switch off the power at the circuit breaker for a couple minutes.

How do I get my thermostat out of lockout mode?

If you don’t know the keypad lockout code, you can force the thermostat to open by touching the “Menu” button and holding your finger there for 20 seconds. The “Menu” button will disappear when you first touch it. When the thermostat unlocks, keep your finger in the same location.

Why is my White Rodgers thermostat not working?

Your White-Rodgers thermostat may be faulty for a number of reasons. The problem may be as simple as needing to replace the batteries. However, your home’s power supply may have blown a fuse or have a tripped breakers, especially if your heating and cooling systems run continuously.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top