How do you secure a ho train track?
Temporarily secure your model train track down It doesn’t matter if it’s HO track laying or laying N scale track, the principle is all the same. Using a tiny piece of blu-tack or double-sided tape is the perfect way to temporarily hold it in place while you make changes or adjust anything.
How do I get rid of LGB rail joiners?
Removing the joiners can be tricky IF you want the joiners undamaged for possible re-use – but if you’re clamping your entire track and are not worried about damaging the joiners, then I’ve found the simple way of removing them is to spread the sides of the joiner apart with a pair of pointed-nose pliers, then grip the …
How do I test my model train battery?
The idea is gloriously simple. Hold a 9volt battery across the wheels with the pickups and the motor should turn. The electricity from the battery replaces the supply that would normally come from the track and it hopefully confirms your intended purchase it worth the money. That’s it.
What’s the best way to solder a track joint?
Basically the idea is to solder the majority of track joints, but leave a gap and and one loose every here and there for expansion and contraction purposes. Just be sure to solder a good feeder on either side of the non-soldered track joint (and most folks recommend pretty much on either side of every joint!) Hope this helps.
What’s the best way to fix a rail joiner?
To fix the kinks identified above–solder the rail joiner and rails then get a small screwdriver. Reheat the joint then use the screwdriver to push the rail into alignment and let the joint cool. The one nail may have to be pulled to allow the track to flex into alignment.
What should I do if my model train is not working?
Tighten any loose joiners and, if necessary, run a second set of wires from the power supply to the track in the troubled area. Make sure to connect each wire to the proper rail.
What to use to clean model train track?
Rubbing alcohol and cleaners like Goo-Gone also work. Never use steel wool to clean your track. The small metal shavings can fall into the armature of the locomotive’s motor and cause damage. Wheels can be cleaned by putting a liquid cleaner on a paper towel across the track. Run cars back and forth across the towel until clean.