How much psi can a KO3 turbo handle?
The K03 can handle much more than 15 psi.
How much boost can a mk5 GTI handle?
Registered. 14 psi is exactly where you should be.
How much boost does a KO4 Turbo make?
The K04 will do 1.85 bar (~27psi) only not for a very long time. It is better to get the results from ignition and normal (20-21 psi) boost pressure. You can expect 375-385 HP if there is enough fuel (hpfp).
What MM is a K03 turbo?
Details about KKK K03 Turbo charger Turbine Wheel Shaft Indcer:45.03mm Exdcer:40.50mm.
How much HP can a 1.8 t handle?
Registered. If your 1.8T is a ’99 through ’01 it is VW rated at 150hp. If it is a ’02 through ’04 & 1/2′ it is rated at 180hp. This is VW rated hp not brake hp.
How much boost does a stock 1.8 t have?
Stock boost is 0.35 bar with the occasional trip to 0.40 bar.
How much boost can a stock ko3 handle?
about 12 psi with any sort of efficiency.
How much boost can a 2.0 t VW handle?
You’re good to about 15psi… BUT… not a constant 15psi and not with stock compression. You would be safe with up 10psi on a regular basis. Most dudes run 5-8psi for daily driving.
How much HP can ko4 handle?
It is said that the K04-01 will get you to max 250-260 crank HP with all the mods like K04 software DP, CAI, DV, etc. If you manage to slap on an Audi TT K04 it can give you about 290-300 cranck HP.
How much boost can a 2.0 TFSI handle?
You’re good to about 15psi…
What size is a KO3?
Re: K03 Turbo Specs (brab) stock KO3 inlet ID on a golf jetta is about 36mm, sport and KO4 being about 38mm, RS4 k4 was about 40, stock s4 was about 32 I think, I dont’ have them on me, but it was basicaly 2 mm jumps, the ID of the inlet should be a hair larger then the minor of the comp wheels, so that seemsa bit off.
Who makes K03 turbo?
Borg Warner
Borg Warner is the original manufacturer of the stock K03 Turbo found on 2.0T FSI engines.
Is there a psi limit for the K03 Turbo?
Conclusion: I respectfully disagree with the mighty SkyPup. The K03 is good to 20-24 psi. At that high end you need to lower the compression ratio and it would be best to improve the intercooler as well. See Sooty’s specs for what can be done with the K03.
Which is better Audi K03 or IHI turbo?
The K04 is obviously a reasonalbe step up from a K03, BUT its still not a very good or efficient turbo. the IHI turbo creates peak boost only 200rpm higher than a K03, and is efficient upto 8000rpm! this means you WILL create peak power at the redline! A much better option for not much more money.
What’s the difference between the older and newer k03-052 turbos?
The differences are only in the actuator that pressure). Otherwise the valve would be pushed open by the exhaust gas pressure. the older versions will bring a slight improvement in engine efficiency. danger of overspeeding the turbo. With the older turbos, 195 hp is the limit. should not be more than 220 hp. That means, changing a K03-052/053/058
What’s the power output of an Audi K03 Turbo?
Additionally, with re-mapping the ECU you can achieve about 215 hp without danger of overspeeding the turbo. With the older turbos, 195 hp is the limit. With the K04 that’s also commonly used (5304 950 0001) the power output should not be more than 220 hp. That means, changing a K03-052/053/058 against a K04 does not make a lot of sense.