How do I connect to SPA112?

How do I connect to SPA112?

Setting up the Cisco SPA112

1. Open a web browser and enter the IP address of the phone adapter in the address bar, then press Enter.
2. Enter the username of the device in the Username field.
3. Enter the password of the device in the Password field.
4. Click Login to enter the web configuration utility.

How do I factory reset my SPA112?

Factory reset your Cisco SPA112 Hold the reset button down for 30s, or until the power LED light begins to flash again. Release the button. Allow the device to boot up; it may take 2-5 minutes for the reset process to complete.

How do I find the IP address of my Cisco SPA112?

At the voice prompt menu, enter 110 #. The phone will read back the IP address of the base, which can be entered into a browser to access the configuration. At the voice prompt menu, enter 210 #. The phone will read back the IP address of the base, which can be entered into a browser to access the configuration.

How do I connect my ATA adapter?

Step 1 Connect the network cable to your network and to the NETWORK port on the ATA. Step 2 Connect the phone cable to the PHONE 1 port on the ATA and to your analog device (phone or fax machine). If connecting a fax machine, connect it directly to the ATA.

How do I setup a Cisco VoIP adapter?

Configuration

1. Obtain the ATA IP address.
2. Type the IP address into your web browser.
3. Once the page has loaded, press Admin Login then press advanced.
4. Go to the SIP tab.
5. Scroll down to RTP Parameters and sets RTP Packet Size to 0.020.
6. Scroll down to NAT Support Parameters and set Handle VIA rport and Insert VIA rport to no.

How do I setup my Grandstream HT801?

Installing Grandstream HT801 ATA Devices

1. Capture the device’s IP Address. Plug in an analog handset into the phone jack, go off-hook, listen for dial tone and dial “***” (three * tones).
2. Reset the HT801 ATA to factory default.
3. Configure the Grandstream HT801 ATA.
4. Click the Advanced Settings menu.

How do I reset my ATA?

Dial the following IVR code using the phone keypad: 73738 (RESET) followed by the # key. The IVR will ask you to confirm by pressing the 1 on the phone keypad. You must hang-up the phone to commence the reboot sequence.

What is an ATA with router?

An analog telephone adapter (ATA) is a device for connecting traditional analog telephones, fax machines, and similar customer-premises devices to a digital telephone system or a voice over IP telephony network. Using such an ATA, it is possible to connect a conventional telephone to a remote VoIP server.

How do I set up an ATA?

Perform the following steps on the ATA Gateway server.

1. Extract the files from the zip file.
2. Run Microsoft ATA Gateway Setup.exe and follow the setup wizard.
3. On the Welcome page, select your language and click Next.
4. The installation wizard automatically checks if the server is a domain controller or a dedicated server.

How do I connect to my ATA fax?

Fax – Analog Telephone Adapter | Connecting the ATA and Fax Machine

1. Connect the power adapter to the “DC 5V Adapter” slot, the small round hole on the right.
2. Connect the Ethernet cable from your router to the “Internet” slot.
3. Connect the Fax Machine RJ 11 cable to “Phone 1”.

What is a analog phone?

A telephone that sends and receives electrical frequencies in the range of the human voice. Analog phones have been the norm since the advent of telephones in the late 1800s. Single-line and two-line phones that plug directly into landlines from the telephone company are analog.